28Faults and repairsIt is not always necessary to call the after-sales service.Sometimes, you can find a remedy yourself. You will find sometips for troubleshooting in the following table.: Risk of electric shock!■ Work on the appliance electronics may only be performed bya specialist.■ Always disconnect the appliance from the power supplywhen work is carried out on the electronics. Switch off thecircuit breaker or remove the fuse from your household fusebox.Problem Possible cause Remedial actionElectrical function is faulty (e.g. indicatorlamps do not light up)Fuse defective Check fuses in the fuse box and replace ifnecessaryLiquid or runny dough runs to one side Appliance not installed level Check the appliance installation (seethe Installation instructions)Appliance no longer works, ‹:‹‹ flashes inthe clock displayThere was a power cut Reset the time of day (seesection: Electronic clock)‹:‹‹ flashes in the clock display,“rrr” appears in the temperature displayThe power supply was interrupted whilethe appliance was in operationPress the KJ clock function button.Reset the time of day (seesection: Electronic clock)“E011” appears in the temperature display Permanent assignment of a button Cancel the permanent assignment of thebutton and press the KJ clock functionbuttonThe temperature display shows, “EXXX”,e.g. E300Internal fault in the appliance electronics Press the KJ clock function button. If themessage does not go out, pull out themains plug and plug it back in again afterapprox. 10 secondsAppliance operation is not possible, Dand -†- appear in the temperature displayThe appliance has been locked Deactivate the lock(see section: Childproof lock)Appliance operation is not possible, Dand -†˜ appear in the temperature displayThe appliance controls were automati-cally blockedDeactivate the permanent lock (seesection: Childproof lock)The appliance does not heat up, the twodots flash in the clock display, and ‚‡‹©appears in the temperature display, forexampleA button combination was actuated Switch off the appliance, press and holdthe ± info button for 3 seconds, then pressand hold the KJ clock function button for4 seconds, then press and hold the ± infobutton again for 3 secondsElectronically controlled functions are mal-functioningEnergy surges (e.g. lightning strike) Reset the function concernedWhen an operating mode is switchedon, • or œ appears in the temperaturedisplayThe appliance has not cooled down fully Wait until the appliance has cooled down,then switch on the operating mode againThe appliance has switched off automati-cally, ‹‹‹ flashes in the temperature dis-playThe appliance has switched off to protectitself from overheatingTurn the operating mode selector back tothe Û positionSmoke is generated during roasting or grill-ingFat is burning on the grill element Continue grilling or roasting until the fat onthe grill element is burnt awayWire rack or universal pan inserted incor-rectlyCheck the shelf levels (see section: Roast-ing or grilling)Higher levels of condensation are gener-ated in the cooking compartmentNormal occurrence (e.g. when bakingcakes with very moist toppings or roastinga large joint)Open the appliance door briefly from timeto time during operationEnamelled accessories have matt, light-coloured marksNormal occurrence caused by drippingmeat or fruit juicesNot possibleDoor panels are misted up Normal occurrence caused by tempera-ture differencesHeat the appliance up to 100 °C and thenswitch off again after 5 minutes