Control ConnectionsThe Power5 has both 12 volt trigger connections and theNHT Bus connection. A 12 volt trigger cable is suppliedwith the Power5.12 Volt Trigger can be used to remotely turn the Power5on or off (in and out of standby mode) when it detects aDC control signal from another component in your sys-tem. The external trigger will accept 5 - 24 volt (DC) sig-nals. For more information regarding external triggers,consult your authorized dealer.The NHT bus connection is an intelligent connection uti-lizing ethernet infrastructure, using a typical CAT5 con-nector. When connected to the NHT Controller it controlson/standby/mute, just like the 12 volt trigger. NOTE:when using the NHT Bus, do not use the 12 volt trigger.The Controller can also turn on and off channels whenyou are listening to five channel surround or just 2 chan-nel stereo. This optimizes the Power5’s power supplyand reduces heat. The NHT Controller can monitoramplifier status as well. The NHT Bus is an open arche-tecture design so more fuctions can be added in thefuture.9