NHT SubOne i User Manual
Also see for SubOne i: Owner's manual
                 | |
!! OperationWhen the SubOne i is turned on, there will be an audible “pop.” Do not be alarmed! This is inherent to theamplifier design and will not damage the subwoofer or your audio system. We do recommend, however, thatthe SubOne i’s power is left “on” at all times, allowing its built-in Standby Mode feature to disable the subwooferwhen not in use.The SubOne i was designed to handle a wide range of listening levels, but every component has limits. It isimportant to use common sense and listen for signs of possible distress from the subwoofer. Noticeable dis-tortion or harsh breakup is an indication that the subwoofer is running beyond its capacity, and the volumeshould be decreased. If you feel heat emanating from the front of the woofer, reduce the level immediately.Speaker damage most often occurs from sustained high volume levels, not from transient sounds or brief musi-cal peaks. Excessive boosting of bass, treble, or equalizer controls can worsen the problem and is not recom-mended.!! MaintenanceYour SubOne i has been designed for years of trouble-free operation and requires minimal maintenance undernormal use. The SubOne i cabinet may be cleaned using a damp cloth or a mild, non-abrasive glass cleaner.to clean the grille, first remove it from the subwoofer, then brush lightly with a soft brush or use a vacuum on itslowest setting. The SubOne i Controller may be cleaned by wiping with a lint-free cloth. Do not expose theSubOne i or the Controller to direct sunlight, high temperatures or moisture. In the event that service isrequired, do not open the SubOne i amplifier or Controller. Refer the unit to a qualified service technician.!! TroubleshootingIf the SubOne i fails to operate when the Power switch is turned on, check the power cord and all inputand output connections thoroughly. Failure to operate could be caused by incorrect wiring, short circuits,or excessive volume. Turn the Power switch on the subwoofer to "off" for two or more seconds to reset.If the LED indicator fails to illuminate, it is possible that mis-wiring or an electrical power surge has caused theprotection fuse to blow. It must be replace with one of correct type and value. Contact your local AuthorizedNHT dealer or NHT immediately for assistance.13 |
Related manuals for NHT SubOne i
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine