NIIMBUS ULTIMATE Series User Manual
                               | |
21SOFTWARESome helpful parameters are adjustable via software.If you are lost in the menus you mayRETURN TO THE DEFAULT SETTINGSby pushing the “1 - XLR“ button for some seconds during powering on.All LEDs are illuminated as long as the “1 - XLR" button is pushed.After releasing the button the unit is set to default state.Menu 1 – LED brightnessPushing long ( > 2 seconds) the "1 - XLR" button will force the corresponding white LED to flash.Pushing the "PHONES OUT" button will decrease the brightness.Pushing the "LINE OUT" button will increase the brightness.When is desired brightness was achieved the result is stored and the procedure is finished by pushingagain the "1 - XLR" button for two seconds, the white LED will stop flashing.Eight steps of brightness are accessible, default is step 3.Menu 2 – Speed of the motorized volume controlPushing long ( > 2 seconds) the "2 - RCA" button will force the corresponding white LED to flash.Pushing the "PHONES OUT" button will decrease the speed.Pushing the "LINE OUT" button will increase the speed.When is desired speed was achieved the result is stored and the procedure is finished by pushing againthe "2 - RCA" button for two seconds, the white LED will stop flashing.Eight steps of speed are accessible, default is step 3.Menu 3 – Switching between pre/post fader (fixed/variable level)of the line outputsPushing long ( > 2 seconds) the "3 - RCA" button will force the corresponding white LED to flash.The current state is indicated by the LEDs for"PHONES OUT" = Pre-Fader (fixed level) or"LINE OUT" = Post-Fader (variable level).Pushing the appropriate button will change the setting.The procedure is finished by pushing again the "3 - RCA" button for two seconds, the white LED will stopflashing. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine