NIVELCO EasyTREK SCD-300 Series Installation And Programming Manual

Also see for EasyTREK SCD-300 Series: Installation and programming manual

Contents

NIVELCO EasyTREK SCD-300 Series Installation And Programming Manual Manual pdf 32 page image

32 / 36 ♦ BKI16ATEX0020X ♦ scd3404a0600p_035.4.9. Error codesErrorCode Error description Causes and actions to be done1 Memory error Contact local agentNo EchoorErr2Echo loss or echo too weak to evaluate Bad reflection from the surface, reflection not directed towards the sensor, due todusting excessive sound absorption. Check device selection and/or adjustmentErr3 Hardware error Contact local agentErr4 Calculation overflow Check settingsErr5 Code referring to sensor error or improperinstallation/mounting, level in the dead bandVerify sensor for correct operation and check for correct mounting according toUsers ManualErr6 The measurement is at the reliability threshold Change aiming or try to find a better locationErr7 No signal received within the measuring rangespecified in P04 and P05. Review programming, also look for installation mistakeErr12 Linearisation table error: L(1) and L(2) are both zero(no valid data-pairs) See the Section ”Linearisation”Err13 Linearisation table error: there are two same L(i) data inthe table See the Section “Linearisation”Err14 Linearisation table error: the r(i) values are notmonotone increasing See the Section “Linearisation”Err15 Linearisation table error: measured Level is higher thanthe last Volume or Flow data-pair See the Section “Linearisation”Err16 The checksum of the program in the EEPROM is wrong Contact local agent