NIVELCO THERMOCONT TT Series Installation And Programming Manual

Contents

NIVELCO THERMOCONT TT Series Installation And Programming Manual Manual pdf 13 page image

BKI 04 ATEX 113X♦ tbj5242a0600p_01.doc ♦ 13 / 165.1.2 Steps of programmingProgramming will be performed by pressing and releasing the relevant one or two keys (simultaneously).The following description is for overview only, detailed programming is to find in 5.1.3For entering calibration value decimal point willautomatically turn up. Its position can not be changed. yy :xxxxy or yy parameter address (0, 1, …19)xxxx or xxxxx parameter value (dcba) orcalibration/measurement valuebargraphsignX–012X0:9X0:9X0:9X0:9O PERATION OF PROGRAMMING KEYS OPERATIONE + (for minimum 3 sec!) * Enter or exit programming mode (Return to the Measurement mode means saving modifications of parameter value)+ GET VALUE – function for automatic setting. Actual/measured value will be accepted as value to be programmed.SET will be displayed for confirmationpressing Keys while Parameter address blinking while Parameter value blinkingE to select parameter address and go to parameter value to save parameter value and return to parameter address+ Cancel all modifications of the actual programmingprocedure. CANCEL will be displayed for warning.Neglect modification of the parameter value (if any) and returnto the parameter address CANCEL will be displayed+ Reset all parameter values to the manufacturer’s setting.(Default). LOAD will be displayed for warningReset to the factory value of the relevant parameter address.LOAD will be displayed for warningMove blinking (changeability) of the digit to the left/ Modify the blinking digit (increase or decrease value, minus sign) or scroll up/down … 8, 9, “ –“ ,0, 1, 2, …Notes:Double key pressing is indicated by “+” * Make sure that E would be pressed first!If after pressing E blinking does not spring over from the parameter address to the parameter value this means that• the parameter is either a read-out type, or• the secret code prevents the modification (see P19)If the modification of the parameter value is not accepted i.e. the parameter value keeps blinking after pressing ENTER E ,• the modified value is either out of the range, or• the code entered is not a valid one

/ 16

Related manuals for NIVELCO THERMOCONT TB Series