NLS iTerm2 Quick Start Manual
          | |
iTerm Rack Kit Installation Guide06/01/06 Rev 1.0 Page 4 of 10SECTION 2Hardware InstallationHardware installation consists of the following steps:• Adjust and mount the removable slide rails in the rack.The slide rails that the terminal tray is delivered with must first be detached from the terminal trayby undoing the front thumb screws, extending the rails fully towards the rear (until they lock),disengaging the exposed safety catches (located midway along each side of the tray), and thencompletely removing the rails towards the rear. The rail length should then be adjusted to matchthat of the rack by slackening the 3 bolts holding the extendible rear rail sections.Bolt the rails into the rack using the 8 included bolts. Please select a height that ensures that theterminal is easily visible, and where the keyboard can be used comfortably. Most racks will allowthe rails to be bolted from the front and rear of the rack. Very deep racks may require the back ofthe rails to be bolted to an internal mid-rail within the rack, in which case the rear rail extensionsshould be reversed so as to present the appropriate mounting holes to the rack mid-rails.• Mount the terminal tray in the slide rails.Ensure that the fitted rails are not extended (by centering the catches located on the inside edgesof the rails), and carefully slide the terminal tray into the fitted rails until it locks in to place. Pleasenote that forcing the terminal tray in to the mounted rails without making certain of a good fit maycause permanent damage to the rail mechanisms. The terminal tray should slide easily whenfitted correctly.When fully extended, the terminal tray will lock in to position. The rail locks must be disengaged by springingthe catches located mid way along the sides of the terminal tray before it can be slid home. |
Related manuals for NLS iTerm2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine