10. As in step 8, mount the lower latch (P/N 6)and upper latch housing (P/N 7) as shown infigure 10a.Note that one side of the lower latchhousing is higher than the other. This is thegate stop. The gate stop should be on theside to which you do not want the gate toopen.If installing the gate by a staircas e, the gatestop must be oriented toward the stairs toprevent the gate from opening over thestairs!Secure both parts to the wall with mountingscrews (P/N 14) as shown in figure 10b.Page 5Mounting lower latch/latch housing9. Insert the upper latch (P/N 4) in the recess inthe upper latch housing (P/N 5) as in figure 9.Secure both parts to the wall with mountingscrews (P/N 14).DE8. Remove the template and mount the upperlatch (P/N 4) and upper latch housing (P/N 5) asshown in figure 8.Note that one side of the upper latch housing ishigher than the other. This is the gate stop.The gate stop should be on the side to whichyou do not want the gate to open.If installing the gate by a staircase, the gatestop must be oriented toward the stairs toprevent the gate from opening over the stairs!Noteraisededge