NRS Healthcare S22479 User Instructions

24. ASSEMBLY4.1 Fit the Side Rails:1. Remove the 4 x E-clips.2. Insert the base slider tubes into the side railassemblies, align the holes and replace theE-clips.3. The bed-stick is now ready for a single bedinstallation, no further adjustment is necessary.Note: You may assemble the bed-stick with reversedside rails, so one faces downwards if not needed.5. INSTALLATION5.1 Adjust for Bed Size:ABCDStandardSingleSmallDoubleStandardDoubleKingSizeBed Width 900 mm 1200 mm 1350 mm 1500 mmPosition A B C D1. Remove the 2 x E-clips as shown.2. Slide the inner slider rails out from the outerslider rail, align the holes and replace theE-clips.Note: Some wood-framed beds may not allow theinner slider rail to extend fully for the E-clips to bereplaced, this will not affect the safety of the bed-stick once the mattress is replaced.5.2 Fitting the Bed-stick to the bed:Note: The next steps may require two people.Remove the mattress and put the bed-stick on thebed base.

/ 4

Related manuals for NRS Healthcare S22479