NUUO 6000S SERIES Installation Manual

Contents

NUUO 6000S SERIES Installation Manual Manual pdf 5 page image

Intelligent Surveillance Solutionpage - 4Hardware InstallationStep1: Insert the card onto an empty PCI-e slot. Connect the Audio/VideoCable to the connector.Note 1: The audio input connectors are with red wires and marked of “A”on them (such as “A1/9”); the video input connectors are with black wiresand marked of “V” (such as “V8/16”).Note 2: You need to power down the PC before you insert the card.Step 2: Connect the Watchdog wire to the reset connector on the mainboard.Note: With the Watchdog Wire connected, the system will be restarted ifany abnormal conditions.Step 3: Turn on your PC and start Windows.Step 3: Insert the included Software CD into CD-ROM.Step 4: Refer the section Driver Installation on page 18 to install driver.Step 5: After driver is installed, restart your PC.Optional I/O Card: refer to the figures on the following pages.Step 1: Fix the IO card onto your PC.Step 2: Connect the Capture Card and the I/O Card with an includedribbon cable (2.00mm IDC cable).Note 1: The default configuration of blue slide switch on I/O Card asbelow.Note 2: If you only use one I/O card to connect with one of 6000S/7000Scards, please make sure the configuration of the black slide switch asbelow.Maximum optional I/O Card support:6000S/7000S can support maximum 4 I/O cards. Please refer to figures onthe following pages.