NUUO NVRsolo User Manual
Also see for NVRsolo: User manualUser manualQuick start guideQuick start guide
                                                                                                                                                                                       | |
Contents
| 
153.3 Connect the Unit and Devices within the NetworkConnect the unit, cameras, and router/switch. If you need to make the videovisible over the Internet, please connect to a “router” with Internet connection,and the unit will retrieve an IP address through DHCP by default.The unit processes built-in DHCP service, which takes the job of router to assign IPaddresses, which is suitable for the pure LAN environment.3.4 Connect the MonitorThe unit processes two display interfaces, VGA and HDMI. Connect the monitor tothe unit.The supporting display resolutions are 1920x1080, 1280x1024, 1280x720, and1024x768. Please confirm that one of the resolution is supported by your monitor.3.5 Power onFor 1bay/2bay unit, attach the power cord from the power source to the poweradapter. Connect the power adapter to the back of the unit enclosure. For 8bayunit, connect the power cord directly to the back of the unit. See the rear viewfigure.Press the power button once connecting the power. See the front view figure.It takes about a minute for the unit to fully power up. Once it is powered up: The System Status LED turns blue The buzzer beeps one timeTo power off the unit, press and hold the power button for 2 seconds until twobeeps are heard. The system will proceed to shut down once the button isreleased.If the system crashes or stops responding, press and hold the power button for 10seconds to enforce hardware power-off, which turns off the computer by cutting offthe power directly. Hence, such power-off isn’t recommended for a system that isworking properly. |
Related manuals for NUUO NVRsolo
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine