NXP Semiconductors DEMOEM User Manual

DEMOEM User Manual 17DEMOEM CODE DEVELOPMENT SOFTWARE for more information.5.3 Run ModeThe DEMOEM’s rich component list empowers it to perform a variety of tasks.Once an application is developed, debugged, and programmed properly intothe EM internal flash memory, it can run with or without connecting to a host.5.4 External BDM ModeThe DEMOEM has an optional BDM header for debugging and programmingthe on-board EM device using an external BDM hardware tool, such as P&E’sUSB Multilink or Cyclone PRO. Please refer to Section 9 - TRANSITIONINGTO YOUR OWN TARGET for more information. A user can take advantage ofthis mode to develop a target-specific EM system and compare it with theDEMOEM when necessary.6 P&E EMBEDDED MULTILINK TOOLKIT PC APPLICATIONSP&E provides several Windows PC-based applications which work with theDEMOEM board. These applications are collectively referred to as the P&EEmbedded Multilink Toolkit. The following applications are included in thetoolkit:6.1 Logic Analyzer ApplicationThe DEMOEM board has a built-in two-channel logic analyzer. This analyzerallows the IN0 and IN1 signals to be captured by the PC and displayed for theuser. The IN0 and IN1 signals may be connected to any of the MCU signalswhich the user would like to view. By default, they are connected to the PTA5and PTA6 pins of the MCU by jumper J18. At the time of this release, the logicanalyzer runs at a capture rate of 10KHz.