188 OCP Quick Guide8.1. Camera Function Portion① CAM PWR SwitchON/OFF control of power supply to the camera head available with this switch. Keep pushingthis switch 2 seconds for power supply OFF from power supply ON.This switch is disabled in the Standalone mode.② VF PWR SwitchThis switch is invalid with the Hi-Motion II.③ Memory Card SlotThis slot is used to save/load the data of Camera Head or CCU setting parameter to/frommemory card (SD Card).Slot should be used for dust proof when memory card is not used. Access indictor lamp on theside of slot lights in saving/loading. Do not remove memory card when access indicator islighting. There is a possibility to damage data of not only memory card but Camera Head andCCU.④ PM IND/PAGE SwitchVarious information of characters is overlaid on CCU PM output. Each of information isindicated sequentially as following by pressing this switch.Self diagnostic information screen >>> Auto setup execution screen >>> Scene fileinformation >>> Hi-Motion II operation screen >>> Camera ID screen⑤ PANEL ENABLE SwitchEnables to OCP operation. OCP control is available when Switch light is ON.⑥ TALLY IndicatorRed, Green and Yellow Tally indicator.⑦ MODE Switch・ STANDARD SwitchTo clear all Camera and CCU data to standard setting. Press this switch to come up LCDmenu and operation is possible with touch panel.By pressing this switch while pressing KNOB FREE switch, changed parameter bycontrol knob rotation can be cleared.・ CAP SwitchSets optical filter to CAP position or Iris close.・ BARS SwitchOutputs Color Bar Signal to Video Output.・ CAL Switch100% or 200% CAL signal is generated for the Calibration of the Video ProcessingCircuit.