Crossover Type Stereo 2 ways + SubwooferCrossover Range Subwoofer: 50 - 250Hz, -24/10dBLow/High : 250-6000Hz, -24/10dBFilter Type (Slope) 2nd order, 12dB/OctaveInputsType Balanced XLR and unbalanced 1/4"Impedance 100 KohmsOutputsType Unbalanced 1/4"Impedance 220 OhmsLow Cut Filters 30Hz/ - 3dB, 12dB/OctaveFrequency Response 20Hz - 25KHz +/-1dBTotal Harmonic Distortion (THD) + Noise < 0.05 %S/N Ratio > 95 dBFuse 1.0 A/ 250V, 5mm glass typeDimensions 19’’ x 1.73’’ x 5.9’’ (483 X 44 X 150mm)Weight 4.4 lbs. (2.2 Kg)SPECIFICATIONSCONNECTION9. FUSE COMPARTMENT:Replace with only the same type fuse (1.0A/250V). If it blows continuously, do not use the unituntil it has been serviced by qualified personnel.10. STEREO INPUT CONECTORS:Connect your L/R stereo input signal to either the balanced XLR or the unbalanced 1/4" input jacks.11. OUTPUT CONECTORS:Connect to your amplifiers via these unbalanced 1/4" output jacks.12. AC VOLTAGE SELECTOR SWITCH:Before plugging in the power cord, check to see that the unit is set for the proper voltage for yourarea:~115V (60Hz) or ~230V (50Hz).13. AC CORDSpecifications and design subject to change without prior notice for improvement purposes5. PHASE SWITCHES:These allow switching the polarity to invert the signal phase on the HIGH ways. This is done afterthe output levels are set to correct audible phase problems.Caution: Before pressing the PHASE switches, always lower the outputs of your power amplifiers toavoid possible speaker damage.6. SUB CROSSOVER FREQUENCY CONTROL:This selects the crossover frequency of the SUB WOOFER way. You can select the frequencybetween 50 Hz to 250 Hz.7. SUBWOOFER OUTPUT LEVEL CONTROL:This is used to adjust the SUB WOOFER output level.8. SUBWOOFER LOW CUT SWITCHES:This inserts a low cut filter in the SUBWOOFER way with a 12dB/Octave, 30 Hz HPF to minimizeproblems from subsonic frequencies in the signal, to suppress hum, and to prevent low frequencysubwoofer speaker resonance.5