Nady Audio CX-23SW Owner's Manual
Also see for CX-23SW: Owner's manual
       | |
FUSE 0.5A/250V HIGH HIGHMID MIDLOW LOWOUTPUTS INPUT INPUTR CHANNEL OUTPUTSL CHANNELSUB WOOFEREmeryville, CA, USAMade in ChinaNADY SYSTEMS, Inc.ATTENTION: SHOCK HAZARD - DO NOT OPENRISQUE DE CHOC ELECTRIQUE NE PAS QUVRIR.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPEN115V/60Hz230V/50HzXLRBALANCEPIN 1 GNDPIN 2 HIPIN 3 LOAC INCrossover Type ..................................................................................Stereo 3 ways + SubwooferCrossover Frequencies Subwoofer..................................................50 - 250HzLM ........................................................................................................70 – 1000HzMH........................................................................................................480 – 7000HzFilter Type (Slope) ..............................................................................2nd order, 12dB/OctaveInputs Type ........................................................................................Balanced Combo 1/4” TRS & XLRImpedance ..........................................................................................100K ΩOutputs Type ......................................................................................Balanced XLRImpedance ..........................................................................................220 ΩLow Cut Filters ..................................................................................30Hz/ - 3dB, 12dB/OctaveFrequency Response ........................................................................25Hz - 25KHz +/-1dBTotal Harmonic Distortion (THD) + Noise ......................................< 0.05 %S/N Ratio ............................................................................................> 80 dBFuse ....................................................................................................0.5 A/ 250V, 5x20mm glass typeDimensions ........................................................................................19’’ x 1.73’’ x 5.9’’ (483 X 44 X 150mm)Weight ................................................................................................4.4 lbs. (2.2 Kg)10. POWER CONNECTORThe IEC jack is used to connect the power cord to the AC Power Source.(Caution: Do not remove the center grounding pin.)11. L/M/H OUTPUT CONNECTORS:Connect to your amplifiers via these balanced XLR output jacks.12. BALANCED INPUT CONNECTORS (Combo 1/4” TRS & XLR):Connect your L/R stereo input signal to these balanced combo jacks. These combination 1/4” TRS (Tip/Ring/Sleeve)phone jacks and XLR jacks are compatible with either type balanced connector and are wired as Tip/Pin 3 = (+),Ring/Pin 2 = (-), and Sleeve/Pin 1 = Ground.13. SUBWOOFER OUTPUT CONNECTOR:Connect to your subwoofer amplifier via this balanced XLR output jack.14. AC VOLTAGE SELECTOR SWITCH:Before plugging in the power cord, check to see that the unit is set for the proper voltage for your area: ~115V (60Hz)or ~230V (50Hz).15. FUSE COMPARTMENT :Replace with only the same type fuse (0.5A/250V). If it blows continuously, do not use the unit until it has been serv-iced by qualified personnel.Specifications and design subject to change without prior notice for improvement purposes5REAR PANEL14 15 11 12CONTROLS AND CONNECTIONSSPECIFICATIONS1013 11 12 |
Related manuals for Nady Audio CX-23SW
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine