Nady Audio MPM 4130 Owner's Manual

Also see for MPM 4130: Owner's manual

Contents

Nady Audio MPM 4130 Owner's Manual Manual pdf 5 page image

FRONT CONNECTIONS5FRONT PANELNote: 1 through 5 below are referenced to Channel 1. The other 3 Channels are identical.(2) (1)(3) (5)(4) (8) (9) (10)(6)(7)(6a) (6b) (6c)(1) LOW EQThe control shelving response giving 15dB of boost or cut at80Hz. Add warmth to vocals or extra punch to guitars, drums andsynths by turning to the right. Turn to the left to reduce stagerumble, hum or to improve a mushy sound.(2) HIGH EQTurn to the right to boost high frequencies, adding crispness toopercussion from drum machines, cymbals and synths. Turn to theleft to cut these frequencies, reducing sibilance or hiss. The con-trol has a shelving response giving 15dB of boost or cut at12kHz.(3) LEVEL CONTROLThe Level Control determines the proportion of the channel signalin the mix, and provides a clear visual indication of channel level.(4) MIC/LINE INPUTThe MIC/LINE is via a combo connector, which allows the con-nections of XLR or 1/4” type phone jack. Please use a low imped-ance microphone and a properly wired cable for best results,When the 1/4” phone jack is plugged into the combo connector,the connection can be either a microphone or line level signal.(5) DIGITAL DELAY (DD)This knob determines the signal level which will be sent to thebuilt-in DIGITAL DELAY Effect (6) control(6) DIGITAL DELAYThe signal from the input channels, processed by the built-in digi-tal delay will feed to the master output. There are three knobshere to control the effect of the delay.(6a) SWITCHThis push button switches the delay effect ON/OFF.(6b) LEVELThis knob adjusts the mix level of the effect sound.(6c) TIME (ms)This knob selects 80ms, 120ms, 160ms, or 200ms ofdelay as desired for your intended effect.(7) POWER ON LED INDICATORIndicates when the unit is ON.(8) TAPE IN CONTROLThis knob adjusts the level of signal from the TAPE IN (10) to theMain bus.(9) MASTER CONTROLThis adjusts the final level of the Main bus. It controls the Mainbus signal which is output to the speakers.(10) TAPE IN AND TAPE OUTThe TAPE IN socket allows cassette recorders or CD players tobe added to the Main output. The RECORD OUTPUT, with TAPEphone sockets, provides signal output to a cassette deck andHome audio equipment. The nominal output level and impedanceare -10dBV/600 ohms.