Nady Audio XA-1100 Owner's Manual

Also see for XA: Owner's manual

Contents

Nady Audio XA-1100 Owner's Manual Manual pdf 7 page image

CONNECTIONS• Stereo (Two-Channel) ModeTo put the amplifier into stereo mode, first turn the amplifier off, then slide the MODE SELECTOR SWITCH (13) to the bottom“STEREO” position, and properly connect the input/output wiring as shown.(Note: Do not connect a speaker load less than 2 ohms as it can damage your amplifier.)The following instructions describe the most common ways to install your amplifier into a sound system.1. Turn off the amplifier power switch before making any connections.2. The XA Series amplifiers maybe operated in one of three modes (stereo, bridged-mono, and parallel mono). Refer to thefollowing wiring diagrams for the speaker connections you wish to make.(Note: Nady Systems assumes no liability for damaged speakers resulting from improper wiring, careless amplifier use, orover powering.)CHANNEL B CHANNEL A7