Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Naked NKD1 Installation & Operating Manual

Also see for NKD1: Installation and setup guide

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Contents
  1. Table Of Contents
  2. Table Of Contents
  3. Important Warnings
  4. GENERAL OVERVIEW
  5. Contents
  6. POOL PREPARATION
  7. NKD1 SYSTEM INSTALLATION
  8. ION Installation
  9. STARTING YOUR NKD1 FRESH WATER SYSTEM
  10. Start Up Information
  11. CONTROL PANEL OPERATION
  12. POWER/MODE
  13. CLOCK/TIMER
  14. Timer Settings
  15. BACKWASH
  16. WINTER MODE
  17. NKD1 FRESH WATER SYSTEM MENU GUIDE
  18. OXI Setting
  19. TDS Test
  20. WATER CHEMISTRY
  21. TDS Levels
  22. Calcium Hardness
  23. SYSTEM MAINTENANCE
  24. Inspecting the ION Rods
  25. SYSTEM TROUBLESHOOTING
  26. SCHEMATICS AND PART NUMBERS
  27. WARRANTY
  28. TECHNICAL SUPPORT
  29. NOTES
Naked NKD1 Installation & Operating Manual Manual pdf 8 page image
4. NKD1 SYSTEM INSTALLATION4.2 Control Unit Installation• The NKD1 Control Unit has an Ingress Protection Rating of IP23 enabling it to be installed outdoors.Regulations require that the Control Unit shall be installed outside the pool zone. The Control Unitshall be installed according to AS/NZS 3000 wiring rules.• The Control Unit should be installed in a well ventilated position ideally away from sunlight andrain to prolong life and at least 1m above ground to prevent run off water entry.• Ensure that the Control Unit is not stored near chemicals, fertilisers or in a closed unventilatedshed with similar products as the fumes will cause excessive corrosion and damage to the internalsof the Control Unit and may void warranty.• When mounting the Control Unit on a post it is recommended to install a at panel at least thesame size to act as a waterproof backing plate.• Mount the Control Unit with the Wall Mounting Bracket, Green Plugs and Screws provided.The Control Unit should be mounted no further than 1.5 metres from the Housing for ease ofoperation.4.1 Installation DiagramOXI & ION CELLFILTERPUMPPOWERCONTROL UNIT(Ensure good venlaon)RETURNTO POOLFROMSKIMMER BOXWARNING: DO NOT plug in if carton has been wet.www.naked-pools.com8
/ 36
This manual is suitable for:
NKD1
Manuals database logo
manualsdatabase
Your AI-powered manual search engine