Nalite Aquator Silver User Manual
Contents |
handle up with the right hand.9.2 Fit the holder with the round silver electrode (12) on the contact (11) located on the cover (9).9.3 Take out the removable containers (3; 4).9.4 Pour water into the bottom container (1) up to the bottom mark (5).9.5 Put the cover (9) on the bottom container (1). The cover and container handles should make acomplete handle.9.6 Insert the corded plug (10) into the mains socket. Press the button (14). The LCD display (19) willshow the message “Water ionizer’. After 4 seconds the message ‘SILVERING PROCESS’. Selectthe silvering process duration: ‘1 s’ should appear. By pressing buttons (17) and (18) select theappliance run time according to Table3. There is no need to press the buttons repeatedly: press andhold until the numbers reach the required value. Then press the START button (16). The green LEDindicator (20) lights up and the green progress bar on the display will show the progress of thesilvering process. After the set time has finished the appliance will switch off automatically with anaudible signal. The green light LED indicator (20) goes out. If you would like to stop the applianceearlier, press the STOP button.9.7 Attention! The appliance running time up to 1 minute is set in seconds and from 2 up to 60minutes - in minutes.9.8 Unplug the plug with a cord (10) from the mains socket, take off the cover (9) .Put the applianceelectrodes on the plate (13). Pour out the silvered water into an opaque container.9.9 Clean the silver electrode (12) and the light electrode (7) carefully with a soft cloth. If theelectrodes are heavy contaminated, clean them with a soft cloth moistened in 9% vinegar. Dark-colored fouling on the silver electrode does not affect the silvered water quality.9.10 Wash the container (1) with water. DO NOT use water to wash the cover (9).9.11 Dry the container (1) and the cover (9). After the parts have fully dried assemble the appliance andstore it in a dry place.9.12 During the production of silvered water for a longer time dark spots appear at the bottom of thecontainer (1). They are caused by silver sediments. These spots do not affect the quality of ionizedand silvered water and further operation of the appliance.10.1 The appliance can be connected to the electric network only when the bottom container (1) andremovable containers (3; 4) are filled with water and the cover (9) is on.10.2 It is forbidden:1. To take the cover (9) off the bottom container (1) when the appliance is plugged to the mains.2. To run the appliance near the open flame and sparkling appliances.3. To switch on the appliance for a longer time than that specified in the instructions.4. To disassemble the appliance!5. To keep cover (9) upside-down after using.6. To use water for washing the cover (9).Keep the appliance away from children and do not leave it unattended.www.nalite.com9. PRODUCTION OF SILVERED WATER (MODIFICATION SILVER)9.1 Remove the appliance cover (9) by holding the bottom container with left hand and pushing the10. SAFETY REQUIREMENTS |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine