Nanov Display NKLT201WPDH User Manual
               | |
))**Setup SettingSearch SetupIt is used for channel search.Start Search : It starts channel search.System : Select ATV Auto Search ModeAuto Search : Auto Search the ON/OFFManual Search 1 : It selects channel the DTVManual Search.Manual Search 2 : It starts the ATV Manual Search.There are two methods of Automatic Tuning andManual Tuning how to tune.Automatic TuningYou should display the Main Menu, pressing themenu key of remote control.You should select the Search Setup menu of theMain Menu, pressing the CH key.You should enter to the Search Setup menu,pressing the ENT key.After selection the Start Search menu using theCH key, Channel search begin as pressingthe ENT key.(System : Pal/Secam Auto search: On, Manual Search 1: All)You can scan the frequency ranges available on yourtelevision in your country and store all the channels foundautomatically.The channels are stored in the order in which theyappear in the frequency bands. It is possible that theautomatically allocated numbers may not correspond tothose by which you wish to identify the channels.If this is the case, you can then sort them manually.Selecting the Sound Mode(depending on TV mode)The "M/S" button displays/controls the processing and output of the audio signal.When power is switched ON, the mode is automatically preset to either "Dual" or "Stereo"depending on the current transmission.If the receiving conditions deteriorate, listening will be easier if the mode is set to the "Mono"position using the M/S button.If the stereo signal is weak (or if intermittent Stereo-Mono) and automatic switching occurs,then switch to the "Mono" mode.When receiving mono sound in the AV mode, connect to the "L" input jack on the panels. Ifthe mono sound comes out only from the left speaker, then press the M/S button.You can adjust the volume by pressing the VOL[ + ] orVOL[ - ] button on the remote control.You can switch the sound off temporarily by pressingthe MUTE button on the remote control, for exampleyou may wish to answer the telephone.1. Press the VOL[ + ] button to increase the volume.(cursor moves to the right)2. Press the VOL[ - ] button to decrease the volume.(cursor moves to the left)3. Press the MUTE button.Result : The sound is switched off and" Mute On" is displayed.4. When you wish to turn the sound back on at thesame volume as before, press the MUTE buttonagain (or either of the volume buttons).Adjusting the Volume/Switching the Sound Off Temporarily |
Related manuals for Nanov Display NKLT201WPDH
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine