Napoleon 410 Manual

Also see for 410: Instructions Instructions Manual Instructions

Contents

Napoleon 410 Manual Manual pdf 3 page image

www.napoleongrills.com5Natural Gas Hook-UpThis natural gas grill is supplied with a 10ft supply hose (complete with a quick disconnect) designed for naturalgas and certified for outdoor use. The gas grill is designed to operate at an inlet pressure of 7 inches watercolumn. Piping and valves upstream of the quick disconnect are not supplied. The installation must com plywith CAN B149.1 Natural Gas and Propane installation code in Canada, or to the National Fuel Gas Code,ANSI Z223.1 in the United States. The gas supply pipe must be sufficiently sized to supply the BTU/h specifiedon the rating plate, based on the length of the piping run. The quick disconnect must not be installed in anupward direction and a readily accessible manual shut-off valve must be installed upstream of, and as close to,the quick disconnect as is feasible. The flared end of the hose must be connected to the fitting on the end ofthe flex tube as illustrated in the Natural Gas Hose Attachment diagram. Tighten using two wrenches. (Do notuse thread sealer/pipe dope.) These connections must be made by a licensed gas installer. Leak test all jointsprior to using the gas grill.WARNING! The installation must be performed by a licensed gas fitter, and all connections must beleak tested before operating the grill.• Do not route hose underneath drip pan.• Do not route hose between space in bottom shelf and back panel.• Do not route hose over top of back panel.• Ensure all hose connections are tightened using two wrenches. Do not use teflon tape or pipe dope onany hose connection.• Ensure the hose does not contact any high temperature surfaces, or it may melt and leak causing a fire.• Do not use enclosure to store excess hose, as there is a greater chance of the hose contacting a hotsurface, it may melt and leak causing a fire.• Leak test all the connections using a soap and water solution, as per the leak testing instructions found inthe this manual.Leak Testing InstructionsWARNING! A leak test must be performed annually and each time a cylinder is hooked up or if a partof the gas system is replaced.WARNING! Never use an open flame to check for gas leaks. Be certain no sparks or open flames arein the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage toproperty, serious bodily injury, or death.Leak testing: This must be done before initial use, annually, and whenever any gas components are replacedor serviced. Do not smoke while performing this test, and remove all sources of ignition. See Leak TestingDia gram for areas to check. Turn all burner controls to the off position. Turn gas supply valve on.Brush a half-and-half solution of liquid soap and water onto all joints and connections of the regulator, hose,manifolds and valves.Bubbles will indicate a gas leak. Either tighten the loose joint or have the part replaced with one recommend edby the Napoleon Customer Care department and have the grill inspected by a certified gas installer.If the leak cannot be stopped, immediately shut off the gas supply, disconnect it, and have the grill inspectedby a certified gas installer or dealer. Do not use the grill until the leak has been corrected.EN