Napoleon BEF33H Installation And Operating Insctruction Manual

Also see for BEF33H: User guide Service manual

Contents

Napoleon BEF33H Installation And Operating Insctruction Manual Manual pdf 15 page image

ENW415-1299 / D / 12.03.14154.2 OPERATING BY REMOTE CONTROL! WARNINGTO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES ANDCHILDREN. DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY.KNOT BEFORE THROWING AWAY.A. Make certain the appliance’s main power switch is at the ONposition on the control board. The appliance will default to thebrightest flame setting when main power is initially switched to ONposition.B. The power button can be used to power up or down the appliance(the main power switch on the appliance must be in the ON positionfor the remote to operate). Pressing this button activates thepower to the appliance. Pressing this button again will turn offthe appliance. The ember and log will fade out after 4 seconds.C. To adjust the flame brightness, press the flame button . Thereare three brightness levels to cycle through and then an off setting(F1, F2, F3 and then F0).F3 is the brightest level.D. To begin the thermostat function press the thermostat button ,there are 7 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F 86°Fand off). Press the thermostat button to cycle through the settings.Once you have selected the desired temperature the heater willautomatically function until that temperature is reached. The defaultsetting will display Fahrenheit. When the room temperature is adegree lower than the temperature setting, the heater will turn on.E. To activate the heater, press the heater button . The blower andheater will turn on. Press the heater button again to turn off theheater, the blower will remain on for 8 seconds.F. To activate the timer, press the timer button , the icon willilluminate and the time will appear on the LED display. To choosethe desired time, continue to press the timer button, there are 6settings (1hour, 2h, 3h, 4h, 5h and off), each setting represents hours of operation. The fireplace willturn off at the setting time.G. To activate the decoration light, press the light button .There are three settings to cycle throughand then an off setting (d1, d2, d3 and then d0). d1 white colour, d2 colour cycles from white to orangeto blue to orange & blue to blue & orange to white & blue. It will take 8.5 seconds to switch from onecolour to the next when in d2 setting, d3 will lock to a desired colour.H. To turn off the appliance, press the power button once on the remote, or switch the main power to off/on the control panel on the unit.NOTE: This hand held remote control must remain within 6 meters or 19 feet of the appliance to beeffective.NOTE: When operating the remote control, it must be directed towards the front center of the appliance.