37W415-0663 / E / 08. 23.127.0 OPTIONAL BLOWER INSTALLATIONINSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must beelectrically connected and grounded in accordance with local codes. In theabsence of local codes, use the current CSA C22.1 Canadian electrical codein Canada or the ANSI / NFPA 70 National Electrical Code in the United States.If the appliance was not previously equipped with a blower:Route a grounded 2-wire, 60hz power cable to the receptacle /junction box. At this point, it must be strain relieved and insulated.The three slots on the blower mounting bracket allow ease of adjustment when attachingthe blower. For a quiet running blower, do not allow the assembly to sit on the firebox base.Slide the vibration reducing pad (A) into the clip (C) and up against the threaded stud (B)at the other end. The blower must be able to be positioned entirely onto the pad.To ease installation of the blower, remove the hinge screen and valve control door(lower louvres) from the base of the appliance.Tilt the blower onto its side. Slide it past the controls and into the clip (C).Secure to the threaded stud using the lock washer and wing nut provided.Ensure that the blower does not touch the appliance base or the firebox.Attach the connectors from the black and white wires tothe thermal switch and secure the thermal switch bracketto the bottom left of the unit using the screws provided.Ensure that the thermal switch touches the firebox wall.Attach the connectors from the black and red wires tothe blower.Attach and secure the variable speed switch using thenut provided. Plug the harness cord into the receptacleThe wire harness provided in this kit is a universalharness. When installed, ensure that any excesswire is contained, preventing it from making contactwith moving or hot objects.Because the blower is thermally activated, whenturned on, it will automatically start approximately10 minutes after lighting the appliance and will runfor approximately 30-45 minutes after the appliancehas been turned off. Use of the fan increases the output of heat. Drywall dust will penetrate into the blowerbearings, causing irreparable damage. Care must be taken to prevent drywall dust from coming into contact with theblower or its compartment. Any damage resulting from this condition is not covered by the warranty policy.whiteredVARIABLESPEEDSWITCHBLOWERTHERMALSWITCHSLOTSELONGATEDVARIABLESPEEDKNOB51.1RECEPTACLE /GROUNDSCREWJUNCTION BOXTHERMAL SWITCHABC! WARNINGRISK OF FIRE AND ELECTRICAL SHOCK.TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITHTHIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GASCOMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILLVOID THE WARRANTY AND CERTIFICATION.ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THEAPPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWERCORD BENEATH THE APPLIANCE.THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHENINSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKINGCONTACT WITH MOVING OR HOT OBJECTS.51.5f i r e - p a r t s . c o m