Napoleon CLEARION Series Quick Start Manual

Also see for CLEARion NEFBD50H: Installation and operation manual Installation and operation manual Installation and operation manual

Contents

Napoleon CLEARION Series Quick Start Manual Manual pdf 2 page image

24 Napoleon Road, Barrie, Ontario, Canada L4M 0G8 • 214 Bayview Drive, Barrie, Ontario, Canada L4N 4Y8Fireplaces, Heating and Cooling: 705-721-1212 • Grills: 705 726-4278 • napoleonproducts.comCLEARION™ SERIES ELECTRIC APPLIANCE04/2018ClearancesMinimum Mantel Clearances8” (4.5” for Deep Trim)SIDE VIEWMANTEL8”WALLSIDE VIEW1MM GAP8” (203.2mm)8” (203.2mm) for standard trim4.5” (114.3mm) for deep trim8” (203.2mm)ABABCFramingAppliance InstallationA. Frame the appliance along with the electrical connections.B. Remove the front trims on both front side and back side (see “front trim installation /removal” section in your installation manual).C. Remove the front glasses on both front side and back side (see “front glass installation/ removal” section in your installation manual).D. To determine the installation location of the mounting bracket, ensure to line up theedge of the mounting bracket 1/4” (6.4mm) from the center of the wall sides and 61/8” (156mm) from the bottom of the wall sides (FIG. 1). Use the mounting bracketinstallation templates in your installation manual.6 1/8”(156mm)1/4”(6.4mm)Centerof studFIG. 1#2 x 4#1 x 46 1/8”(156mm)E. Mark the holes for the mounting bracket. Ensure the marked holes are on oppositesides, as the brackets cannot be mounted on the same side (FIG. 2).FIG. 2F. Drill marked holes.G. Secure the mounting brackets onto the drilled holes with supplied fasteners (#1 x 4).H. Insert the appliance to the frame and secure the appliance to the holes on the bracketusing supplied fasteners (#2 x 4) and the slots from the appliance (FIG. 3).FIG. 3I. Install media (see “media installation” section in your installation manual).J. Reinstall front trim and glass (see “front trim installation / removal” and “front glassinstallation / removal” sections in your installation manual).It is recommended to have the walls of the appliance enclosure be finished (i.e. drywall) to avoidexposed insulation or vapour barrier coming in contact with the appliance. This will ensure clearance tocombustibles is maintained.note:Wall anchors are not required when screwing into the wall stud.It is recommended to use a magnetic screwdriver bit during installation to prevent the screws fromfalling into the appliance.Model No. A B CNEFBD50H 17 15/16” (45.6cm) 49” (124.5cm) 8” (203.2mm)NEFBD50H-SS 17 15/16” (45.6cm) 49” (124.5cm) 8” (203.2mm)NEFBD50H-DT 17 15/16” (45.6cm) 49” (124.5cm) 4 1/2” (114.3mm)NEFBD50H-SS-DT 17 15/16” (45.6cm) 49” (124.5cm) 4 1/2” (114.3mm)

/ 2

Related manuals for Napoleon CLEARion NEFBD50H