Napoleon Dynamic Heat Control LVX38 Installation Manual

Contents

Napoleon Dynamic Heat Control LVX38 Installation Manual Manual pdf 9 page image

ENW415-1739 / C / 08.03.179Dynamic Heat Control™ installation4.0 Dynamic Heat Control™ installation1.) Remove fasteners securing front frame (and rearframe for see-thru). Do not discard fasteners.Before starting the Dynamic Heat Control™ installation, remove safety barrier. Refer to “safety barrier installation/removal” section in the installation manualSINGLE-SIDED SHOWNSINGLE-SIDED SHOWN2.) Remove knockouts plates (FOR SINGLE-SIDED, ONLY REMOVETHE TWO KNOCKOUTS PLATES ON THE ACCESS SIDE). Discardknockout plates. Recommended: Use a flathead screwdriver or asmall pry bar and use prying motion to remove the knockout. Usea brace such as a piece of wood under the prying tool to avoid distortingthe top3.) Remove the fasteners securing the cover plates recessed below the knockout plates. For ease of removal, lift the panel from below infront of the firebox door. Discard cover plates.access sideaccess sideCOVER PLATEIMPORTANT:Fire Hazard Warning: This step is crucial for your appliance to work properly. Ifthe knockout plates AND the cover plates are not removed from the viewed side,the appliance will overheat, the barrier will become excessively hot, and the highlimit switch will constantly trip.Front FrameCover Plate