Napoleon EF30 Installation And Operating Instructions Manual

Also see for Electric Fireplace EF30: Installation and operation instructions

Napoleon EF30 Installation And Operating Instructions Manual Manual pdf 15 page image

15W415-0675 / D / 12.14.11Once the appliance has been plugged in to a grounded electrical outlet, it is ready to operate.A. Plug in your electric appliance.B. Make sure the appliance's main power button is at the ON position! The remote control will NOTwork if the main Power button is at the OFF position. NOTE: Ensure the house circuit breakers forthe power supply are turned on. In the event of a power failure, when the main switch is in theON position and the hand held remote control is in the OFF position, the flame generationlights will come on at the high setting, however the heater remains turned off when the poweris restored.C. When operating the remote control, it must be directed towards the front of the appliance.D. The button at the top left corner of the remote is the main power button . Pressing this buttonactivates the power to the appliance. NOTE: The main power switch on the appliance must be inthe ON position for the remote to operate.E. To adjust the ember bed brightness, press the “+” or “-” buttons. To increase the ember bedbrightness, press the “+” button, to decrease the ember bed brightness, press the "-" button.There are seven levels of brightness.F. To activate the heater, press the button. Press and release the button to cycle through LO, MED,HI and OFF. Each time the button is pushed, the appliance LED will change to its correspondingcolor: Green for LO, Orange for MED, Red for HI, and blank for OFF. The appliance has a built-inthermostat so it will shut off automatically once the pre-set temperature is reached. It will also turn onautomatically if the room temperature drops below the pre-set temperature.G. To adjust the height of the flame, press the “+” or “-” buttons. To increase the height of the flame,press the “+” button, to decrease the height of the flame, press the "-" button. There are sevenlevels of flame effects.H. To turn off the appliance, press the button once. NOTICE: This remote control must remainwithin 8 meters or 26 feet of the appliance to be effective and this range may be reduced asbattery power is depleted.REMOTE CONTROL FORELECTRIC FIREPLACEIndicatorLightInfrared Ray Exit- ++-NOTE: Make sure your batteries are fully charged and installed correctly in your remote control.6.1 OPERATING BY REMOTE CONTROL