Napoleon EF30G Installation And Operation Instructions Manual

Also see for EF30G: Installation and operating instructions Installation and operating instructions

Contents

Napoleon EF30G Installation And Operation Instructions Manual Manual pdf 12 page image

W415-0760 / 12.19.08123.5 thermostat and thermal sensor installationthis appliance has two options for heat control.first is a thermal controlled sensor, which comes plugged into the appliance beside the main power cord. thissensor has no user temperature set points, it will turn off the heater when the sensor reaches its pre-set point,and will only turn the heater back on when it has cooled back down below this set point. on the low setting(green light) the set point is 16°c/61°f, on medium (orange light) 22°c/72°f and on high (red light) 28°c/82°f.this small sensor can be placed anywhere in the room within the length of the sensor wire, but it should not beplaced near the top or front of the appliance. placing the sensor too close to the heater area of the appliancewill cause unwanted cycling of the heater.second is the option of a wall-mounted thermostat. napoleon part # W690-0001, W660-0081, or an equivalentlow voltage thermostat.A wall thermostat can be used in place of the thermal control sensor. You must first remove the sensor byunplugging it from the right side of the appliance beside the main power cord. replace the sensor with the wireharness provided in the manual baggie. plug it into the appliance and connect the other end to the thermostat.the thermostat should be placed as per the thermostat installation instructions.figurE 3.5a figurE 3.5bfigurE 3.5c