Napoleon GD17 - N Installation And Operation Instructions Manual

Contents

Napoleon GD17 - N Installation And Operation Instructions Manual Manual pdf 15 page image

15WS-415-106 /05.19.99OPTIONAL BLOWER INSTALLATIONINSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must beelectrically connected and grounded in accordance with local codes. In theabsence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE inCanada or the ANSI/NFPA 70-1996 NATIONAL ELECTRICAL CODE in the United StatesIf the fireplace was not previously equipped with a blower: route agrounded 2-wire, 60hz power cable to the receptacle / junction box. At this point, itmust be strain relieved and insulated.The three slots on the blower mountingbracket allow ease of adjustment whenattaching the blower. For a quiet runningblower, do not allow the assembly to siton the firebox base.Slide the vibration reducing pad (A) into the clip (C) and up against the threadedstud (B) at the other end. The blower must be able to be positioned entirelyonto the pad.Tilt the blower onto its side. Slide it past the controlsand into the clip (C). Secure to the threaded stud usingthe lock washer and wing nut provided. Ensure that theblower does not touch the fireplace base or the firebox.Attach the connectors from the black and white wires tothe thermodisc and secure the thermodisc bracket tothe securing stud at the bottom left of the unit using alock washer and wing nut. Ensure that the thermodisctouches the firebox wall.Attach the connectors from the black and red wires tothe blower.Attach and secure the variable speed switch using thenut provided. Plug the harness cord into the receptacle.The wire harness provided in this kit is a universal harness. When installed, ensure that any excesswire is contained, preventing it from making contact with moving or hot objects.Because the blower is thermally activated, when turned on, it will automatically start approximately 10minutes after lighting the fireplace and will run for approximately 30-45 minutes after the fireplace hasbeen turned off. Use of the fan increases the output of heat.redwhiteblackFIGURE 30FIGURE 35RECEPTACLE /THERMODISCGROUNDSCREWJUNCTION BOX FIGURE 34CCFIGURE 31SLOTSELONGATEDFIGURE 33FIGURE 32ABC