Napoleon GD33NR Installation And Operating Instructions Manual

Also see for BGD33NR: Installation and operating instructions Installation and operating instructions Installation and operation instructions

Contents

Napoleon GD33NR Installation And Operating Instructions Manual Manual pdf 39 page image

39W415-0662 / C / 04.11.126.2 LOG PLACEMENTPHAZERTM logs and glowing embers exclusive to Continental, provide a unique and realistic glowing effect that isdifferent in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colourpigments burn in during the heat activated curing process.! WARNINGFAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USEONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTYDAMAGE OR PERSONAL INJURY.LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THEPROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYEDIGNITION MAY OCCUR.THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.76.1A6.3 BGD33Place log #1 onto the burner, centering it on the logsupport and pushing it as close to the rear wall of thefirebox as possible.A BSit the bottom of log #2 onto the locating pin on theleft side of the log support. Position the top of the loginto the pocket provided on the top of the rear log (#1).C DPosition the notch located in the bottom end of log #3against the centre grate post. Rest the top of log #3 intothe pocket at the top end of log #2.NOTE: There are 2 extra logs included in this GL-638 log set. These small charcoal logs (part#W135-0082and W135-0182) are not meant for use in the BGD33. For these models these two logs must be discarded.Place the bottom of log #4 onto the locating pin on theright side of the log support. Rest the top into the pocketprovided on the center log (#3).6.3.1 GLOWING EMBERSTear the glowing embers into pieces and place onto the smallcarry ports. Care should be taken to shred the embers intothin, small irregular pieces as only the exposed edges of thefibre hairs will glow when exposed to direct flame; howevercare should be taken to not block the burner ports. Blockedports can cause an incorrect flame pattern, carbon depositsand delayed ignition.SMALL CARRYPORTSSMALL CARRYPORTS