2W415-0341 / K / 10.05.07PG 3-5 INTRODUCTIONWarrantyGeneral InstructionsGeneral InformationCare of Glass & Plated PartsDimensions5-14 VENTINGVenting LengthsAir Terminal LocationsVenting Application Flow ChartVenting Specifications15-24 INSTALLATIONWall & Ceiling ProtectionUsing Flexible Vent ComponentsUsing Rigid Vent ComponentsRestricting Vertical VentsMobile Home InstallationGas InstallationFramingNailing Tab InstallationMantle Clearances & Enclosures25-27 FINISHINGLog PlacementDoor Removal & InstallationLogo PlacementLouvre Removal & Installation28 OPTIONAL BLOWER29-30 OPERATION / MAINTENANCEOperating InstructionsMaintenance30 ADJUSTMENTSPilot Burner AdjustmentVenturi Adjustment31-33 REPLACEMENTSOrdering Replacement PartsReplacement PartsAccessoriesVent KitsTerminal Kits34-35 TROUBLE SHOOTING GUIDE36 NOTESNOTE: Changes, other than editorial, are denoted by a vertical line in the margin.WARNING• Do not burn wood or other materials in this fireplace.• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay awayto avoid burns or clothing ignition. Supervise young children when they are in the same room as the fireplace.• Clothing or other flammable material should not be placed on or near the fireplace.• Due to high temperatures, the fireplace should be located out of traffic and away from furniture and draperies.• Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.• Even after the fireplace is out, the glass and/or screen will remain hot for an extended period of time.• Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hotsurfaces. These screens and guards must be fastened to the floor.• Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.• It is imperative that the control compartments, burners and circulating blower and its passageway in the fireplaceand venting system are kept clean. The fireplace and its venting system should be inspected before use and at leastannually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting,bedding material, etc. The fireplace area must be kept clear and free from combustible materials, gasoline andother flammable vapours and liquids.• Under no circumstances should this fireplace be modified.• This fireplace must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.• Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspectthe fireplace and to replace any part of the control system and any gas control which has been under water.• Do not operate the fireplace with the glass door removed, cracked or broken. Replacement of the glass should bedone by a licensed or qualified service person.• Do not strike or slam shut the fireplace glass door.• This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple suppliedby Wolf Steel Ltd.• Pressure relief doors must be kept closed while the fireplace is operating to prevent exhaust fumes containingcarbon monoxide, from entering into the home. Temperatures of the exhaust escaping through these openings canalso cause the surrounding combustible materials to overheat and catch fire.• Only doors / optional fronts certified with the unit are to be installed on the appliance.TABLE of CONTENTSPLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE