Napoleon GD36NTR Installation And Operating Instructions Manual

Also see for BGD36NTR: Installation and operation instructions Installation and operating instructions Installation and operation instructions Installation and instruction manual Installation and operating instructions

Napoleon GD36NTR Installation And Operating Instructions Manual Manual pdf 6 page image

6W415-0210 / S /03.10.091.4 GENERAL INSTRUCTIONSIf the optional fan or blower is installed, the junction box must be electrically connected and grounded in ac-cordance with local codes. In the absence of local codes, use the current CSA C22.1 Canadian Electrical Codein Canada or the ANSI/NFPA 70 National Electrical Code in the United States.Always light the pilot whether for the first time or if the gas supply has ran out, with the glass dooropened or removed.Provide adequate accessibility clearance for servicing and operating the appliance.Provide adequate ventilation.Never obstruct the front opening of the appliance.Objects placed in front of the appliance must be kept a minimum of 48” from the front face of the unit.This product must be installed by a licensed plumber or gas fitter when installed within the commonwealthof Massachusetts.Fire risk. Explosion Hazard.High Pressure will damage valve. Disconnect gas supply piping before pressure testing gas line at test pressuresabove 1/2 psig. Close the manual shut-off valve before pressure testing gas line at test pressures equal to orless than 1/2 psig.Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Using non-listedaccessories (blowers, doors, louvres, trims, gas components, venting components, etc.) could result in a safetyhazard and will void the warranty and certification.! WARNINGTHIS GAS APPLIANCE SHOULD BE INSTALLED AND SERVICED BY A QUALIFIED INSTALLER to conform with localcodes. Installation practices vary from region to region and it is important to know the specifics that apply to your area, forexample in Massachusetts State:• The appliance damper must be removed or welded in the open position prior to installation of a appliance insert or gas log.• The appliance off valve must be a “T” handle gas cock.• The flexible connector must not be longer than 36 inches.• A Carbon Monoxide detector is required in all rooms containing gas fired appliances.• The appliance is not approved for installation in a bedroom or bathroom unless the unit is a direct vent sealedcombustion product.The installation must conform with local codes or, in absence oflocal codes, the National Gas and Propane Installation CodeCSA B149.1 in Canada, or the National Fuel Gas Code,ANSI Z223.1 / NFPA 54 in the United States. Suitable for mobilehome installation if installed in accordance with the currentstandard CAN/CSA Z240MH Series, for gas equipped mobilehomes, in Canada or ANSI Z223.1 and NFPA 54 in the UnitedStates.When the appliance is installed directly on carpeting, vinyl tile or other combustible material other than wood flooring, theapplinace shall be installed on a metal or wood panel extending the full width and depth.We suggest that our gasheart products be installedand serviced by professionalswho are certified in the U.S.by the National ApplianceInstitute® (NFI) as NFI GasSpecialistswww.nficertified.org4.1