Napoleon GDS25N Installation And Operating Instructions Manual

Also see for Bayfield GDS25P: Installation and operating instructions Installation and operation instructions Installation and operation instructions Installation and operating instructions Installation and operating instructions

Napoleon GDS25N Installation And Operating Instructions Manual Manual pdf 35 page image

35W415-0547 / G / 12.15.1010.3 CARE OF GLASS5.1DO NOT CLEAN GLASS WHEN HOT! DO NOT USEABRASIVE CLEANERS TO CLEAN GLASS.Buff lightly with a clean dry soft cloth. Clean both sidesof the glass after the first 10 hours of operation with arecommended fireplace glass cleaner. Thereafter cleanas required. If the glass is not kept clean permanentdiscoloration and / or blemishes may result.HOT GLASS WILLCAUSE BURNS.DO NOT TOUCH GLASSUNTIL COOLED.NEVER ALLOW CHILDRENTO TOUCH GLASS.! WARNING10.4 CARE OF PLATED PARTS6.1If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the platedsurfaces before operating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean.If not cleaned properly before operating for the first time, the marks can cause permanent blemishes onthe plating. After the plating is cured, the fingerprints and oils will not affect the finish and little maintenanceis required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may causediscolouration on plated parts.NOTE: The protective wrap on plated parts is best removed when the assembly is at roomtemperature but this can be improved if the assembly is warmed, using a hair dryer or similar heatsource.10.2 PILOT INJECTOR AND ORIFICE REPLACEMENTORIFICELOCATIONBURNERASSEMBLYThis must be carried out by an AUTHORIZED REPRESENTATIVE OF WOLF STEELLTD. or a QUALIFIED GAS INSTALLER in accordance with local codes or in theabsence of local codes with the requirements of the provincial / state authorities havingjurisdiction and in accordance with the requirements of the CAN1-B149 Installation Codein Canada and the ANSI Z223.1 National Fuel Gas Code in the United States.A. Turn off the electrical and gas supply to the appliance.B. Remove the cast front, glass viewing door and log set.C. Remove the 2 securing screws. Slide the burner assembly to the right and liftout.D. Using a deep socket wrench, remove the main burner orifice. A back-up wrenchmust be used on themanifold, located below the housing to ensure that thealuminum tubing does not twist or kink. Replace the correct burner orifice usingpipe thread compound.E. Loosen nut and replace with appropriate injectorF. Reinstall the burner ensuring that the Venturi tube fits over the orifice.G. Turn on the gas supply and check for gas leaks by brushing on a soap and water solution.Do not use open flame.H. Replace the log set. Then light the pilot and main burner to ensure that the gas lines havebeen purged.I. Replace the glass viewing door and cast front. Turn on the electrical supply to theappliance.! WARNINGALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUTWITH THE GLASS DOOR OPEN OR REMOVED.