Napoleon GDS26N Installation And Operating Instructions Manual

Also see for Castlemore GDS26N: Installation and operation instructions Installation and operating instructions Installation and operating instructions Installation and operation instructions

Napoleon GDS26N Installation And Operating Instructions Manual Manual pdf 37 page image

37W415-0827 / D / 08.10.128.0 OPERATIONMAIN BURNER SWITCHThis switch turns the Main Burner on and off.NIGHT LIGHTTM SWITCHThis switch turns the Night Light TM on and off.FAN CONTROL OPTIONIf installed this switch will turn on and off the power to theblower and control the fan speed. There is also a thermallyactivated switch that will only let the blower come on oncethe appliance has reached a comfortable temperature.MAINBURNERSWITCHNIGHTLIGHTTMSWITCH FANCONTROLOPTIONTOP VIEW8.1 SWITCH FUNCTIONSEnsure that a continuous gas flow is at the burner before installing the door. When lit for the first time, the appliance will emit an odor for afew hours. This is a normal temporary condition caused by the "burn-in" of paints and lubricants used in the manufacturing process and willnot occur again. After extended periods of non-operation such as following a vacation or a warm weather season, the appliance may emit aslight odor for a few hours. This is caused by dust particles in the heat exchanger burning off. In both cases, open a window to sufficientlyventilate the room.FOR YOUR SAFETY READ BEFORE LIGHTING:A. This appliance is equipped with an ignition device which automatically lights he pilot. Do not try to light by hand.B. Before operating smell all around the appliance area for gas and next to the floor because some gas is heavier than air and will settle onthe floor.C. Use only your hand to turn the gas control knob. Never use tools. If the knob will not turn by hand, do not try to repair it. Call a qualifiedservice technician. Force or attempted repair may result in a fire or explosion.D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance andreplace any part of the control system and any gas control which has been under water.ƔTurn off all gas to the appliance.ƔOpen windows.ƔDo not try to light any appliance.ƔDo not touch any electric switch; do not use any phonein your building.1. Stop! Read the above safety information on this label.2. Turn remote wall switch to off position.3. Turn off all electrical power to the appliance and remove batteries.4. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.5. Turn manual shutoff valve clockwise to off.6. Open the glass door.7. Wait five (5) minutes to clear out any gas. If you smell gas including near the floor, STOP! Follow “B” in theabove safety information on this label. If you don’t smell gas go to the next step.8. Close the glass door.9. Turn manual shutoff valve counter-clockwise to on.10. Turn on all electrical power to the appliance and re-install batteries.11. Turn on remote wall switch to on position.12. If appliance will not operate, follow instructions “TO TURN OFF GAS” and call yourservice technician or gas supplier.1. Turn off remote wall switch to the appliance.2. Turn off all electrical power to the appliance if service is to be performed.3. Turn manual shutoff valve clockwise to off. Do not force.ƔImmediately call your gas supplier from a neighbor'sphone. Follow the gas supplier's instructions.ƔIf you cannot reach your gas supplier, call the firedepartment.WHAT TO DO IF YOU SMELL GAS:LIGHTING INSTRUCTIONS:TO TURN OFF GASManual Shut-offValve Shown in“OFF” position .47.6IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULTCAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITHTHE GLASS DOOR OPENED OR REMOVED.! WARNING