Napoleon GDS26N Installation And Operating Instructions Manual

Also see for Castlemore GDS26N: Installation and operation instructions Installation and operating instructions Installation and operating instructions Installation and operation instructions

Contents

Napoleon GDS26N Installation And Operating Instructions Manual Manual pdf 35 page image

W415-1333 / 06.25.1435EN7.0 OPTIONAL BLOWER INSTALLATIONELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected andgrounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 CanadianElectrical Code in Canada or the current ANSI/NFPA 70 National Electrical Code in the United States.A. Break out the blower and thermal switch knock-outs from the rear panel.B. Fish the wire extension through the blower knock-out as shown and connect to the prongs on the thermalswitch.C. Ensure the thermal switch is touching the wall of the firebox. Secure thethermal switch assembly to the rear panel using 4 of # 8 screws supplied.D. Connect the variable speed switch to the jumper wire (installed in theappliance) located just inside the larger knock out area.E. Insert the blower assembly into the rear panel and secure using theremaining #8 screws supplied.F. Remove the switch housing, connect the variable speed switch to the jumperwire and mount the switch to the side of the housing. Attach and secure the variable speed switch usingthe nut provided. Reinstall the switch housing. Install the variable speed switch knob.WHITEREDBLACKGREEN(GROUND)THERMAL SWITCHVARIABLE SPEED SWITCHBLOWERWIREEXTENSIONWIREHARNESS(included in GS67 kit)BLACKTOPOWERSUPPLYLOCATEDIN WIREHOUSINGJUMPER WIRE (installed in fireplace)GS67 WIRING DIAGRAMVARIABLESPEEDSWITCHKNOB! WARNINGRISK OF FIRE AND ELECTRICAL SHOCK.TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITHTHIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GASCOMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILLVOID THE WARRANTY AND CERTIFICATION.ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THEAPPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWERCORD BENEATH THE APPLIANCE.THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHENINSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKINGCONTACT WITH MOVING OR HOT OBJECTS.51.5BLOWERASSEMBLYTHERMALSWITCHASSEMBLYGROUNDSCREWSWITCHHOUSINGVARIABLESPEEDSWITCHLOCATIONTHERMAL SWITCHKNOCK-OUTBLOWERKNOCK-OUT