Napoleon GDS60-1NSP Installation And Operating Instructions Manual

Contents

Napoleon GDS60-1NSP Installation And Operating Instructions Manual Manual pdf 38 page image

W415-1329 / 06.25.1438EN14235Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. Phazer tm logsglow when exposed to direct flame and provide a unique and realistic glowing effect. Use only certified phazer tmlogs available from your Napoleon® dealer.Place log #1 onto the burner, centering it onto theburner tray and pushing it as close to the rear wallof the firebox as possible. Move logs # 2 and 3 intoposition, lining up the studs located on the burnerwith the holes on the bottom of the logs. Sit the notchat the bottom of log #4 against the left outermostgrate post and position the top of the log into thepocket provided on the rear log (#1).The notch in log #5 should be pressed down ontothe skewering pin located at the end of the grate asshown to prevent it from rocking.6.4 GLASS / DOOR REPLACEMENTA. Place the door frame face down careful not toscratch the paint.B. Center the gasketed glass inside the door framewith the thick side of the gasket facing up.C. Bend the glass retainers located along the edgeof the door frame over the gasket holding theglass in place. Careful not to break the glass.! WARNINGDO NOT USE SUBSTITUTE MATERIALS.GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS ORDAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THEAPPLIANCE BEFORE OPERATION.DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASSREMOVED, CRACKED, BROKEN OR SCRATCHED.56.1A6.5 LOG PLACEMENTGLASSGASKETDOORFRAMEGLASSRETAINER