Napoleon GI3016-N Installation And Operation Instructions Manual
Also see for GI3016-N: Installation and operation instructionsInstallation and operation instructions
                | |
10W415-0171 / C / 06.11.02FRESH AIR DAMPER SYSTEMIf your masonry fireplace is equipped with a fresh air inletin the floor of the firebrick chamber, the insert is able totake outside air directly into the unit through an opening inits base thereby eliminating the need to use preheatedroom air for combustion. The flow of air may be adjustedthrough the use of a damper located below the louvre ac-cess door. The damper should be kept closed (pushed allthe way in) when the unit is not in operation or if no outsideair is available. The damper is fully open when pulled for-ward (one inch from the closed position).FIGURE 20OPERATION / MAINTENANCENever obstruct the flow of combustion orventilation air.OPERATING INSTRUCTIONSWhen lit for the first time, the stove will emit a slight odourfor a few hours. This is a normal temporary conditioncaused by the curing of the logs and the "burn-in" of inter-nal paints and lubricants used in the manufacturing proc-ess and will not occur again.Simply open a window to sufficiently ventilate the room.After extended periods of non-operation such as followinga vacation or a warm weather season, the fireplace mayemit a slight odour for a few hours. This is caused by dustparticles in the heat exchanger burning off. Open a windowto sufficiently ventilate the room.Call a qualified service technician. Force or attemptedrepair may result in a fire or explosion.D Do not use this insert if any part has been under water.Immediately call a qualified service technician to inspectthe unit and replace any part of the control system andany gas control touched by water.FOR YOUR SAFETY READ BEFORE OPERATINGA This stove has a pilot which must be lit by hand whilefollowing these instructions exactly.B Before lighting, smell all around the fireplace area forgas and next to the floor because some gas is heavierthan air and will settle on the floor.C Use only your hand to push in or turn the gas controlknob. Never use tools. If the knob will not push in or turnby hand, do not try to repair it.• Immediately call your gas supplier from a neighbour'sphone. Follow the gas supplier's instructions.• If you cannot reach your gas supplier, call the fire de-partment.WHAT TO DO IF YOU SMELL GAS:• Do not try to light any appliance.• Do not touch any electrical switch; do not use any phonein your building.8. Depress and hold the gas knob while lighting the pilotwith the push button igniter. Keep the knob fully de-pressed for one (1) minute, then release. If the pilot doesnot continue to burn, repeat steps 3 through 7.9. With the pilot lit, turn the gas knob counter-clock-wise to "on" position.10. If your insert is equipped with a flame adjustmentvalve, push and turn the knob to "high".11. If your insert is equipped with a remote "on-off" switch,the main burner may not come on when you turn the gasvalve to "on" or "high". The remote switch must be in the"on" position as well to ignite the main burner.12. Turn on all electrical power to the insert.LIGHTING INSTRUCTIONS:1. Stop! Read all the safety information above. Whenlighting and relighting, the gas knob cannot be turnedfrom "pilot" to "off" unless the knob is depressed.2. Turn off all electrical power to the stove.2. Turn the gas knob clockwise to off.4. Wait 5 minutes for any gas in the combustion cham-ber to escape. Continue to the next step if you do NOTsmell any gas. If you smell gas, STOP! and follow theinstructions in "What to do if You Smell Gas" listed above.5. If the unit is equipped with a flame adjustment valve,turn clockwise to off.6. Locate the pilot situated in front of the rear log.7. Turn the gas knob counter-clockwise to "pi-lot" position.2. Push in gas control knob slightly and turn clock-wise to off. Do not force.INSTRUCTIONS TO TURN OFF GAS:1. Turn off all electrical power to the unit if service isto be performed.THERMOPILEELECTRODEPILOT BURNERGAS VALVE |
Related manuals for Napoleon GI3016-N
manualsdatabase
Your AI-powered manual search engine