Napoleon GSS36N Installation And Operating Instructions Manual

Also see for GSS36N: Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operating instructions

Contents

Napoleon GSS36N Installation And Operating Instructions Manual Manual pdf 12 page image

12W415-0807 / 06.25.09IMPORTANTIT IS HIGHLY RECOMMENDED TO PROTECT THE LOGS FROM MOISTURE.COVER THE FIREBOX WHEN NOT IN USE.4.0 FINISHING4.1 LOG PLACEMENT! WARNINGLOGS MUST BE PLACED IN THEIR EXACT LOCATION IN APPLIANCE. DO NOT CHANGE FROM THEPROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYEDIGNITION MAY OCCUR.THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.PHAZERTM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that isdifferent in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colourpigments burn in during the heat activated curing process.4.1.1 Place the rear log so that it rests against thetwo log brackets on the back wall of the fire-box. The air space between the log and fireboxback is used to facilitate combustion air flow.4.1.2 Move the charcoal strip into position liningup the holes in the bottom with the studslocated on the burner on the burner. Ensurestrip sits flat on the burner.4.1.3 Position the front right log just behind thegrate lining up the holes in the bottom withthe studs located on the log support.4.1.4 Move the left log into position lining up thehole in the bottom with the stud on the leftside of the log support.4.1.5 Line up the square hole in the right crossoverwith the square post located on the right sideof log and install as shown.4.1.6 Line up the rectangular hole in the left cross-over with the rectangular post located on theleft side of log and install as shown.