10WS-415-131 / A / 09.11.00BLOWER INSTALLATIONINSTALLATION TO BE DONE BY A QUALIFIED INSTALLERand must be electrically connected and grounded in accord-ance with local codes. In the absence of local codes, use thecurrent ANSI/NFPA 70-1996 NATIONAL ELECTRICAL CODE.If the fireplace wasnot previouslyequipped with ablower: route agrounded 2-wire, 60hzpower cable to the junc-tion box. At this point, itmust be strain relievedand insulated.The three slots on theblower mounting bracketallow ease of adjustmentwhen attaching theblower. For a quiet run-ning blower, do not allowthe assembly to sit on thefirebox base.Slide the vibration reducing pad (A) into the clip (C) and upagainst the threaded stud (B) at the other end. The blowermust be able to be positioned entirely onto the pad.Tilt the blower onto its side. Slide it past the controls andinto the clip (C). Secure to the threaded stud using the lockwasher and wing nut provided. Ensure that the blowerdoes not touch the fireplace base or the firebox.Attach the connectors from the black and white wires to thethermodisc and secure the thermodisc bracket to the se-curing stud at the bottom left of the unit using a lock washerand wing nut. Ensure that the thermodisc touches the fire-box wall.Attach the connectors from theblack and red wires to theblower.Attach and secure the variablespeed switch using the nut pro-vided. Plug the harness cordinto the receptacle.The wire harness provided in this kit is a universalharness. When installed, ensure that any excesswire is contained, preventing it from making con-tact with moving or hot objects.Because the blower is thermally activated, whenturned on, it will automatically start approximately10 minutes after lighting the fireplace and will runfor approximately 30-45 after the fireplace hasbeen turned off. Use of the fan increases the out-put of heat.Drywall dust will penetrate into the blower bear-ings causing irreparable damage. Care must betaken to prevent drywall dust from coming intocontact with the blower or its compartment. Anydamage resulting from this condition is not cov-ered by the warranty policy.redwhiteblackRECEPTACLE /THERMODISCGROUNDSCREWJUNCTIONBOXSLOTSELONGATEDFIGURE 16FIGURE 17CABFIGURES 18FIGURE 19FIGURE 20