Napoleon GVF40P Installation And Operating Instructions Manual

Also see for GVF40N: Installation and operation instructions Installation and operation instructions Installation and operating instructions Installation and operating instructions

Napoleon GVF40P Installation And Operating Instructions Manual Manual pdf 25 page image

25W415-0810 / A / 05.04.109.0 OPTIONAL BLOWER INSTALLATIONTHIS BLOWER IS NOT RECOMMENDED FOR THE 4 SIDED INSTALLATIONINSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must beelectrically connected and grounded in accordance with local codes.In theabsence of local codes, use the current ANSI/NFPA 70 National Electrical Codein the United States. Remove the blower from its mounting bracket and attach tothe bracket supplied with the appliance. This bracket is found secured on themounting stud located at the bottom of the vent side wall.Route a grounded 2-wire, 60Hz power cable to thejunction box. At this point, it must be strainedrelieved and insulatied.The blower bracket contains twoholes that allow the blower to bepositioned away from the intendedgas supply hole.Position the vibration reducing pad, centred, onto the threaded stud, piercing a holeinto the pad. The blower must be able to be positioned entirely onto the pad.Tilt the blower onto its side and slide it past the controls. Position the blowerunder the clip and onto the stud. Secure with a wing nut.Remove the thermal switchbracket from the top of thefirebox.Remove the thermal switch from the bracket supplied in the blowerkit and install the thermal switch into the appliance bracket. Thenreplace the bracket in the location it was removed.Connect the two ends of the unattached wires by the bracket tothe thermal switch.Connect the opposite ends of the wires to the red and black leadsof the blower harness.blackwhiteredVARIABLESPEEDSWITCHBLOWERTHERMAL SWITCHVIBRATIONREDUCING PADWING NUT&LOCK WASHER! WARNINGRISK OF FIRE AND ELECTRICAL SHOCK.TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITHTHIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GASCOMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILLVOID THE WARRANTY AND CERTIFICATION.ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THEAPPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWERCORD BENEATH THE APPLIANCE.THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHENINSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKINGCONTACT WITH MOVING OR HOT OBJECTS.51.5