6W415-0810 / 06.11.091.3 GENERAL INSTRUCTIONS! WARNINGCARBON MONOXIDE POISONING MAY LEAD TO DEATHEARLY SIGNS OF CARBON MONOXIDE POISONING RESEMBLE THE FLU, WITH HEADACHE, DIZZI-NESS AND/OR NAUSEA. IF YOU HAVE THESE SIGNS, THE HEATER MAY NOT BE WORKING PROP-ERLY. GET FRESH AIR AT ONCE! HAVE HEATER SERVICED.SOME PEOPLE---PREGNANT WOMEN, PERSONS WITH HEART OR LUNG DISEASE, ANEMIA, THOSEUNDER THE INFLUENCE OF ALCOHOL, THOSE AT HIGH ALTITUDES--- ARE MORE AFFECTED BYCARBON MONOXIDE THAN OTHERS.THIS HEATER MUST NOT BE INSTALLED IN A BEDROOM OR BATHROOM.THE HEATER IS ONLY FOR USE WITH THE TYPE OF GAS INDICATED ON THE RATING PLATE. THISHEATER IS NOT CONVERTIBLE FOR USE WITH OTHER GASES.OBJECTS PLACED IN FRONT OF THE HEATER SHOULD BE KEPT A MINIMUM OF 48” AWAY FROMTHE GLASS FRONT FACES OF THE HEATER.USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITHTHIS APPLIANCE. USING NON-LISTED ACCESSORIES AND REPLACEMENT PARTS (BLOWERS,LOUVRES, TRIMS, GAS COMPONENTS, VENT COMPONENTS, ETC.) COULD RESULT IN A SAFETYHAZARD AND WILL VOID THE LIMITED LIFETIME WARRANTY.This gas appliance should be installed and serviced by a qualified installer to conform with local codes.Installation practices vary from region to region and it is important to know the specifics that apply to yourarea, for example: in Massachusetts State:• The appliance off valve must be a “T” handle gas cock.• The flexible connector must not be longer than 36“.• The appliance is not approved for installation in a bedroom or bathroom unless the appliance is a directvent sealed combustion product.• A carbon monoxide detector is required in all rooms containing gas fired appliances.• WARNING: This product must be installed by a licensed plumber or gas fitter when installed within thecommonwealth of Massachusetts.• Un-vented room appliance shall be installed in accordance with 527 CMR 30.00 and 248 CMR 3.00through 7.00.• Sellers of un-vented propane or natural gas-fired space / room appliances shall provide to each purchasera copy of 527 CMR 30.00 upon the sale of the appliance from http://www.napoleonfireplaces.com/Webshare/installation_manuals/mass_requirements.pdfIn absence of local codes, install the appliance to the current National Fuel Gas Code, ANSI Z223.1Installation Code which can be obtained from:American National Standards Institute Inc. or National Fire Protection Association Inc.1430 Broadway Batterymarch ParkNew York, NY 10018 Quincy, MA 02269The appliance and its individual shutoff valve must be disconnected from the gas supply piping system duringany pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa). The appliance must beisolated from the gas supply piping system by closing its individual manual shutoff valve during any pressuretesting of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa). Wheninstalled with a blower the junction box must be electrically connected and grounded in accordance with localcodes. In the absense of local codes, use the current ANSI / NFPA 70 National Electric Code. In the casewhere the blower is equipped with a power cord it must be connected into a properly grounded receptacle.The grounding prong must not be removed from the cord plug.