Napoleon GVF42P Installation And Operating Instructions Manual

Also see for GVF42N: Installation and operation instructions Installation and operating instructions

Napoleon GVF42P Installation And Operating Instructions Manual Manual pdf 25 page image

25W415-0379 / E / 04.24.12COMPONENTSREF PART NO. DESCRIPTION1* W357-0001 PIEZO IGNITER2 W662-0001 NATURAL GAS OXYGEN DEPLETION SENSOR SYSTEM2 W662-0005 PROPANE GAS OXYGEN DEPLETION SENSOR SYSTEM3* W680-0004 THERMOPILE4 W725-0030 NATURAL GAS VALVE4 W725-0031 PROPANE GAS VALVE5* W385-0430 NAPOLEON LOGO6* GD-660 STANDARD WALL SWITCH & 20FT OF WIRE7 GL-633 LOG SET8* W361-0079 GLOWING EMBERS9* W550-0001 CHARCOAL EMBERS10* W550-0002 CHARCOAL LUMPS11* W361-0014 VERMICULITE12 W135-0150 BACK - LOG #1Contact your dealer or the factory for questions concerning prices and policies on replacement parts. Normallyall parts can be ordered through your Authorized dealer / distributor.FOR WARRANTY REPLACEMENT PARTS, A PHOTOCOPY OF THE ORIGINAL INVOICE WILL BEREQUIRED TO HONOUR THE CLAIM.When ordering replacement parts always give the following information:• Model & Serial Number of appliance• Installation date of appliance• Part number• Description of part• Finish* IDENTIFIES ITEMS WHICH ARE NOT ILLUSTRATED. FORFURTHER INFORMATION, CONTACT YOUR AUTHORIZED DEALER. 41.1FAILURE TO POSITION THE PARTSIN ACCORDANCE WITH THISMANUAL OR FAILURE TO USE ONLYPARTS SPECIFICALLY APPROVEDWITH THIS APPLIANCE MAYRESULT IN PROPERTY DAMAGE ORPERSONAL INJURY.! WARNING10.0 REPLACEMENTS9.2 CARE OF PLATED PARTS6.1If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the platedsurfaces before operating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean.If not cleaned properly before operating for the first time, the marks can cause permanent blemishes onthe plating. After the plating is cured, the fingerprints and oils will not affect the finish and little maintenanceis required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may causediscolouration on plated parts.NOTE: The protective wrap on plated parts is best removed when the assembly is at roomtemperature but this can be improved if the assembly is warmed, using a hair dryer or similar heatsource.