35W415-1089 / 08.08.128.0 WIRING DIAGRAM / ELECTRICAL INFORMATION! WARNINGDO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIEDSERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THEELECTRICAL CIRCUIT.RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THEAPPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCEWITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIANELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 INTHE UNITED STATES.ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUT,WITH THE GLASS DOOR OPENED OR REMOVED.69.28.1 WIRING REQUIREMENTSThis appliance must be electrically connected and grounded in accordance with local codes. In the absenceof local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the ANSI/NFPA 70-1996 NATIONAL ELECTRICAL CODE in the United States.8.2 JUNCTION BOX INSTALLATIONA. Remove the two screws that secure the junction box assembly to the outershell on the left side of the fire place and remove the junction box assembly.B. Remove the one screw that secures the junction box to the junction boxplate and slide off the clip.C. Route the supply wire through the 7/8” hole of the junction box plate with abox connector (not supplied).D. Connect the 120 volt supply wire to the receptacle as perthe CSA C22.1 Canadian Electrical Code in Canada or theANSI/NFPA 70-1996 National Electrical Code in the UnitedStates.E. Once the wiring is complete, re-install the junction box tothe junction box plate and re-secure the screw that wasremoved in step B.F. Re-install the junction box assembly by reversing step Amaking sure all plugs are secure in the junction box.NOTE: If the appliance is already installed inside the enclosure, you can access the junction box frominside the appliance by removing the burner base assembly, see “ACCESSING THE BLOWER” section.AB 1B 2It is necessary to hard wire this appliance.Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.This appliance must be electrically connected and grounded in accordance with local codes. In the absenceof local codes, use the current CSA C22.1 Canadian electrical code in Canada or the ANSI/NFPA 70-1996national electrical code in the United States.