Napoleon HDX40NT-1 Installation And Operating Instructions Manual

Also see for HDX40NT-1: Installation and operating instructions Installation and operating instructions

Contents

Napoleon HDX40NT-1 Installation And Operating Instructions Manual Manual pdf 29 page image

W415-1349 / A / 03.18.1529EN6.0 OPTIONAL BLOWER INSTALLATION! WARNINGRISK OF FIRE AND ELECTRICAL SHOCK.TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITHTHIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GASCOMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILLVOID THE WARRANTY AND CERTIFICATION.ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THEAPPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWERCORD BENEATH THE APPLIANCE.THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHENINSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKINGCONTACT WITH MOVING OR HOT OBJECTS.51.5! WARNINGBE CAREFUL NOT TO TEAR THE BURNER TRAIN GASKET. A REPLACEMENT GASKET CAN BEORDERED FROM YOUR LOCAL AUTHORIZED DEALER / DISTRIBUTOR.6.1 ACCESSING THE BLOWERA. Remove the control access panel.B. Remove the door, see the section “DOOR REMOVAL / INSTALLATION”.C. Carefully remove the log set and optional brick panels if installed, see section “LOG PLACEMENT”.D. Remove the 2 screws holding the front grate in place.E. Remove the 2 screws holding the rear log support.F. Remove the 9 perimeter screws as illustrated and lift out the burner base assembly and gasket.(The gas line flex-connector should provide sufficient movement to permit shifting the burnerassembly on it’s side).FRONTGRATE REAR LOGSUPPORTCONTROL ACCESS PANELPERIMETER SCREWS