ENW415-1720 / 08.21.17 7general information• Depending on the loading method and size of log, maximum length of 18” (45.7cm).• Large glass door for maximum visibility.• Fully refractory lined firebox.• Closable outside combustion air damper.• Closable flue damper.• Shipping weight, without firebricks, 552lbs (250kg).• Net weight, with firebricks, 745 lbs (338kg).• Shipping weight of firebricks, 225lbs (102kg).• Flue outlet diameter 10” (254mm).• Max. fuel load 45lbs (20kg).• Max. fuel height, halfway or top of the first firebrick.2.2 featuresApproximate heating capacity up to 1,000 square feet (92 square meters).2.3 this cordwood fuel fireplace! WARNING• Do not let the appliance become hot enough for any part to glow red.2.4 packing listShipped with appliance:Installation manual Door Tool HardwareOwner’s manual GlovesEmber Strip AndironsTHE NZ5000 HAS BEEN EPA QUALIFIED.CALIFORNIA PROP 65 WARNING:Use of this product may produce smoke which containschemicals known to the State of California to causecancer, birth defects, or other reproductive harm.Do not use makeshift compromises during installation.Do not block or restrict air, grille or louvre openings! Donot add a hood.Burning your appliance with the door open or ajar creates a fire hazard that may result in a house and/orchimney fire.All venting connections must be in compliance with the chimney manufacturers installation instructions.Clearances referred to throughout this manual are the minimum requirements.Your appliance must be installed in accordance with all national and local building code standards andthe standard of Chimney and Appliances, Vents and Solid Fuel Burning Appliances NFPA #211. Consultthe authority having jurisdiction (such as municipal building department, fire department, fire preventionbureau, etc.) to determine the need to obtain a permit. If you are in doubt about the proper installation foryour situation, contact your dealer or local building or fire official. The manufacturer does not guaranteethat this appliance and its options will completely heat your entire home.Expansion / contraction noises during heating up and cooling down cycles are normal and to beexpected.It is recommended that in all cases, the appliance be secured to the floor. Use the pallet packing bracketsto accomplish this.