Napoleon HYBRID 150 Installation And Operating Instructions Manual

Also see for HMF150: Operating instructions Installation and operating instruction

Contents

Napoleon HYBRID 150 Installation And Operating Instructions Manual Manual pdf 8 page image

W415-1013 / C / 11.19.138ENThe Napoleon HMF150/200 may take outside combustion air directly into the appliance through a 4" (102mm)inlet collar at the back of the unit. This inlet is to supply combustion air for the HMF150/200 Wood Furnaceonly.Secure and seal the intake liners to the collars using 3 sheet metal screws, and high temperature sealant.For detailed clearance to combustibles, see Section 6.0 for plenum and consideration of venting location.3.0 INSTALLATION PLANNING3.1 LOCATION AND CLEARANCES3.2 OUTSIDE COMBUSTION AIRH3.32WEAR GLOVES AND SAFETY GLASSES FOR PROTECTION.KEEP HAND TOOLS IN GOOD CONDITION, SHARPEN CUTTING EDGES AND MAKE SURE TOOLHANDLES ARE SECURE.DO NOT MAKESHIFT COMPROMISES DURING INSTALLATION. DO NOT BLOCK OR RESTRICT AIR.DO NOT IMPEDE AIR MOVEMENT ZONES MARKED “CLEARANCE TO COMBUSTIBLES”.H3.33AFOR C/HMF150 DO NOT INSTALL INTO ANY AREA HAVING A HEIGHT LESS THAN 6 FEET 3 INCHES(1.9M) (CAN BE REDUCED TO 6 FEET (1.8M) WHEN SHIELDING SPECIFICATIONS ARE MET). SEESECTION 6.3.FOR C/ HMF200 DO NOT INSTALL INTO ANY AREA HAVING A HEIGHT LESS THAN 7 FEET (2.13M)(CAN BE REDUCED TO 6 FEET 9 INCHES (2.06M) WHEN SHIELDING SPECIFICATIONS ARE MET) SEESECTION 6.3.THIS APPLIANCE, CONFIGURED WITH ALL MODULES, WEIGHS: C/HMF150 - 700LBS (318KG), C/HMF200 - 830LBS (375KG). ENSURE THERE IS ADEQUATE FLOOR SUPPORT FOR THE APPLIANCE.THE VERTICAL HEIGHT OF THE AIR INTAKE LINER MUST NOT BE GREATER THAN 2/3 THE HEIGHT OFTHE CHIMNEY.H3.34DO NOT DRAW OUTSIDE AIR FROM GARAGE SPACES. EXHAUST PRODUCTS OF GASOLINECOMBUSTION ENGINES ARE HAZARDOUS.DO NOT DRAW OUTSIDE AIR FROM ATTIC SPACES, BASEMENTS OR ABOVE THE ROOFINGWHERE OTHER HEATING APPLIANCES OR FANS AND CHIMNEYS EXHAUST OR UTILIZE AIR.THESE PRECAUTIONS WILL REDUCE THE POSSIBILITY OF APPLIANCE SMOKING OR AIR FLOWREVERSAL.THE OUTSIDE AIR INLET MUST REMAIN CLEAR OF LEAVES, DEBRIS ICE AND/OR SNOW. IT MUSTBE UNRESTRICTED WHILE APPLIANCE IS IN USE TO PREVENT COMBUSTION AIR STARVATIONWHICH CAN CAUSE SMOKE SPILLAGE AND AN INABILITY TO MAINTAIN A FIRE. SMOKE SPILLAGECAN ALSO SET OFF SMOKE ALARMS.NEGATIVE PRESSURE WITHIN YOUR HOME MAY INADVERTENTLY AFFECT YOUR APPLIANCE.EXHAUST FANS SUCH AS BATHROOM FANS, RANGE HOODS AND CLOTHES DRYERS CANSTRONGLY INFLUENCE NEGATIVE PRESSURE IN THE HOUSE.AIR INLET TERMINALS MUST BE INSTALLED WITH ADEQUATE GROUND CLEARANCE AND BESUFFICIENTLY SHIELDED FROM PREVAILING WINDS TO PREVENT FROM REVERSING IN THE VENTSYSTEM.