Napoleon High Country NZ3000 Installation And Operating Instructions Manual

Also see for NZ3000: Installation and operating instructions Installation and operating instructions

Napoleon High Country NZ3000 Installation And Operating Instructions Manual Manual pdf 6 page image

W415-0711 / 10.03.0862.0 gENErAL iNFOrmATiON• Maximum log length of 25" • Large firebox capacity - 2.78 cu. ft.• Long burn time - up to 12 hours • Large doors with ceramic glass for maximum visibility• Firebrick lining for firebox protection • Optional 440 CFM blower for convection heat• Thermostat for automatic control of the blower • Inside or outside air for combustion• BTU Output per hour 10,000 to 60,000 (Cord wood method)Shipped with fireplace: Shipped with faceplate:Installation manual Installation instructions and hardwareBaffle Shipped with the door(s):Ember Strip Installation instructions and hardware2.1 FEATurES2.2 HEATiNg SpECiFiCATiONSApproximate Heating Capacity up to 3,000 square feet (Will vary with the home's floor plan, insulation and outside temperature).2.3 ELECTriCAL SpECiFiCATiONSWhere applicable the blowers and motors draw < 12 amps.2.4 pACkiNg LiST2.5 CALiFOrNiA prOp 65Use of this product may produce smoke which contains chemicals known to the State of California to causecancer, birth defects, or other reproductive harm.Your fireplace must be installed in accordance with all national and local building code standards and the standardof Chimney and Fireplaces, Vents and Solid Fuel Burning Appliances NFPA #211. Consult the authority having juris-diction (such as municipal building department, fire department, fire prevention bureau, etc.) to determine the needto obtain a permit. If you are in doubt about the proper instal-lation for your situation, contact your dealer or local buildingor fire official. The manufacturer does not guarantee that thisfireplace and its options will completely heat your entire home.Negative pressure within your home may inadvertently affectyour fireplace.TP - CARE OF GLASS_WOODAll wiring should be done by a qualified electrician and shall be in compliance with local codes andwith the National Electric Code ANSI/NF No. 70-current (in the United States), or with the currentCSA C22.1 Canadian Electric Code (in Canada).This fireplace has not been tested with any vented or unvented gas log set. To reduce risk of fire orprevent injury, do not install a vented or unvented gas log set into the fireplace.2.6 EpA COmpLiANCEThis heater has been tested in accordance with standard 40, section 60 of the Environmental Protection Agency(EPA).