Napoleon LHD50N Installation And Operating Instructions Manual

Also see for LHD50N: Installation and operating instructions Installation and operating instructions Installation and operating instructions

Contents

Napoleon LHD50N Installation And Operating Instructions Manual Manual pdf 36 page image

36W415-0745 / B / 06.08.106.0 FINISHINGFRONT - ACCESS SIDE6.1.1 Locate the door latches 6” from the top corners of the doorbetween the main door and framing edge.6.1.2 Insert the latch key and pivot up to disengage door latches.6.1.3 Tilt the top of the door forward until you can grab the sides ofthe door. Lift up and out of the bottom door retainer.6.1.4 When re-installing the door, lift onto the bottom door retainer,tilt the top towards the appliance and secure the latches.BACK OF TWO SIDED ONLY6.1.5 Remove the four screws holding the door to the appliance.6.1.6 Tilt the top of the door forward until you can grab the sides ofthe door. Lift up and out of the bottom door retainer.6.1.7 When re-installing the door, lift onto the bottom door retainer,tilt the top towards the appliance and secure with the fourremoved screws.6.1 DOOR REMOVAL / INSTALLATION! WARNINGGLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DONOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIROPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FORSERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TOTHE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.75.1IMPORTANT: Once latches are engaged,test that the door is secure and will notfall forward before letting go.! WARNINGRISK OF FIRE!NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.THE FRONT OF THE APPLIANCE MUST BE FINISHED WITH ANY NON-COMBUSTIBLE MATERIALSSUCH AS BRICK, MARBLE, GRANITE, ETC., PROVIDED THAT THESE MATERIALS DO NOT GOBELOW THE SPECIFIED DIMENSION AS ILLUSTRATED.DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASSREMOVED, CRACKED, BROKEN OR SCRATCHED.FACING AND/OR FINISHING MATERIAL MUST NEVER OVERHANG INTO THE APPLIANCE OPENING.THE GLASS DOOR ASSEMBLY IS DESIGNED TO PIVOT FORWARD WHEN RELIEVING EXCESSPRESSURE THAT MIGHT OCCUR. FINISHING OR OTHER MATERIALS MUST NOT BE LOCATED INTHE OPENING SURROUNDING THE DOOR AS THIS WILL INTERFERE WITH THE DOORS ABILITY TORELIEVE THE PRESSURE.72.6