Napoleon LHD62N Installation And Operating Instructions Manual

Also see for LHD62N: Installation and operating instructions Installation and operating instructions

Contents

Napoleon LHD62N Installation And Operating Instructions Manual Manual pdf 47 page image

W415-1068 / B / 01.02.1447EN*Prior to removing the burner follow the “DOOR REMOVAL” proccess and then follow the media removalinstructions located under the “MAINTENANCE” section.A. Remove the media tray by removing all screws securing the front, rear and side panels.B. Remove the 8 screws that secure the burner/mesh to the appliance.C. Carefully lift the burner mesh as well as the burner straight up through the venturi housing mesh, asshown in the illustration below.D. Repeat this process on the other burners, if replacement or removal is necessary.VENTURI HOUSINGBURNER MESHBURNERMEDIA TRAYPrior to removing the burner follow the “DOOR REMOVAL” process and then follow the media removalinstructions located under the “MAINTENANCE” section.A. Remove the media tray by removing all screws securing the front, rear and side panels.B. Remove the 22 screws securing the burner/mesh to the appliance.C. Remove the rear right side and then the right side porcelain panels, follow removal instructions underthe “ PORCELAIN PANEL REMOVAL” section. To access the controls remove the 12 screws securingthe access plate. NOTE: It will be necessary to replace the gasket (W290-0197) for the access plate ifthe unit has been previously operated before removing the plate.D. Remove the pilot tube bulk head plate from the appliance by removing the two screws, on the lowerright side of the appliance. Disconnect the pilot tubing. Remove the pilot wire bulk head by removingthe two screws, then disconnect the inside wire.E. Disconnect the fl ex connector from the valve and pivot the burner assembly up and out, ensure care istaken when removing as to not twist or kink the gas lines.F. Remove the burner assembly from the firebox, care should be taken to ensure avoiding damage to thegasket.11.4 BURNER REMOVAL11.5 BURNER ASSEMBLY REMOVAL