Napoleon LV38N Instructions Manual

Also see for LV38N: Installation and operating instructions

Napoleon LV38N Instructions Manual Manual pdf 1 page image

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliancemay result in property damage or personal injury.CAUTION: Before proceeding with conversion the gas supply must be shut off prior to disconnecting the electrical power.1. Remove the safety screen, glass door and media.2. Disengage the air shutter control rod by wiggling and pushing the rod to the left. *3. Remove the 10 screws (5 per side) that secure the media tray and burner assembly in place. Lift this assembly up and out of the appliance.4. Using a deep socket wrench, remove the orifice from the firebox and replace with the orifice supplied (#37 for NG, #52 for LP).5. Remove the two screws from the valve regulator and remove the regulator, replace with the one supplied (refer to Figure 1).This conversion kit shall be installed by a qualifi ed service agency in accordance with themanufacturer’s instructions and all applicable codes and requirements of the authority havingjurisdiction. If the information in these instructions is not followed exactly, a fi re, explosionor production of carbon monoxide may result causing property damage, personal injury orloss of life. The qualified service agency is responsible for the proper installation of this kit.The installation is not proper and complete until the operation of the converted appliance ischecked as specified in the owner instructions supplied with the kit.FUEL CONVERSION KITS FOR MODELLV38N / LV38N2These kits are for use at altitudes of 0 to 4500 feet.INSTALLER: THESE INSTRUCTIONS ARE TO REMAIN WITH THE HOME OWNER.CHECK THE BOXES TO INDICATE THAT THE CORRESPONDING STEPS HAVE BEEN COMPLETED.Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • (705)721-1212 • fax (705)722-6031 • www.napoleonfireplaces.comContinued on reverseW175-0423, Propane to Natural Gas Includes;STEP MOTOR / REGULATOR 1#37 BURNER ORIFICE 1CONVERSION DATA LABEL 1NATURAL GAS PILOT INJECTOR 1W415-1581 / B / 03.16.166. Remove the pilot hood from the pilot assembly by removing the retaining clip and pulling vertically. Use a 5 /32 ”Allen key to unscrew the injector. Replace the pilot injector with the one supplied. Re-assemble the pilot hood ontothe assembly ensuring key position for proper alignment. Reinstall retaining clip.7. The conversion data label must be filled out and attached adjacent to the valve.8. Re-install the burner and media tray assembly. Turn on the electrical supply to the appliance.9. Verify the center of the pilot hood is 1” 1/8” away from the first burner port (refer to Figure 2).10. Engage the air shutter control rod by locating the stud on the shutter with the grommet on thecontrol rod. Wiggle and push the knob to the right until the stud is totally inserted in the grommet.PILOTHOODPILOTINJECTORFigure 1 Figure 2W175-0424, Natural Gas to Propane Includes;STEP MOTOR / REGULATOR 1#52 BURNER ORIFICE 1CONVERSION DATA LABEL 1PROPANE GAS PILOT INJECTOR 1+-* A rubber grommet inserted into the control rod provides a snug fit.

/ 4

Related manuals for Napoleon LV38N