46W415-1439 / A / 07.10.15ENEN8.2 TEMPERATURE DISPLAYA. With the system in the “OFF” position, press theTemperature Key and the Mode Key at the sametime to change from degrees F to C.B. Look at the LCD screen on the Transmitter toverify that a C or F is visible to the right of theRoom Temperature display.35.5A73°F23°CThe remote control has six (6) flame levels. With thesystem on and the flame level at the maximum, pressthe Down Arrow Key once and it will reduce the flameheight by one step until the flame is turned off.The Up Arrow Key will increase the flame height eachtime it is pressed. If the Up Arrow Key is pressed whilethe system is on but the flame is off, the flame willcome on the high position. A single “beep” will confirmreception of the command.35.8A76°FOFF76°F76°F76°FHiFLAME OFF FLAME AT LEVEL 1FLAME AT LEVEL 5 FLAME AT “HI” LEVEL 68.3 FLAME HEIGHT(4) AA Batteries8.4 INITIALIZING THE TRANSMITTER/BATTERY HOLDER FOR THE FIRST TIMEA. Install the 4 AA batteries into the Proflame 2 battery holder, note the polarity of the batteries and insertas indicated on the cover (+/-).B. Ensure the 3 position slider switch is switched to the “REMOTE” position (middle position).C. Press the reset/programming button, use a small object such as a paper clip in order to reach thebutton marked PRG, as shown in the illustration below.D. The battery holder will beep 3 times to indicate that it’s ready to synchronize with the transmitter.E. Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ONbutton, The battery holder will beep 4 times to indicate that the transmitter’s command is accepted.NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS OF PRESSING THERESET/PROGRAM BUTTON (PRG).TRANSMITTERRESET/PROGRAMBUTTON (PRG)BATTERY HOLDERSLIDER SWITCH
